National Technical University of Athens (NTUA)
Προστασία οπλισμένου σκυροδέματος με χρώματα
Abstract
dc:descriptionThe aim of the thesis was the protection of reinforced concrete by coatings and specifically the protection of lightweight concrete with pumice, a Greek lightweight aggregate. Six parameters that influence reinforcing steel corrosion and protection from outside factors that affect negatively the integrity of steel or concrete were evaluated. These parameters were type of cement, organic and inorganic coatings, type of reinforcing steel, aggregate gradation, addition of alkali-silica reaction inhibitor and corrosion inhibitors. Reinforced specimens were exposed in three different corrosive environments: accelerated corrosion in salt-spray chamber, medium-term corrosion in partial immersion in 3.5% wt. NaCl solution and long-term corrosion in atmospheric exposure. The influence on steel and mortars of the above mentioned parameters was evaluated by time evolution of corrosion potential and determination of mass loss of steels, measurement of carbonation depth in pumice mortars and measurement of chloride diffusion rate through mortars. Also porosity and mean diameter of mortar pores and corrosion rate by the linear polarization technique and electrochemical impedance spectroscopy were measured and visual inspection in thin sections of mortars and macroscopic examination by fiber optic microscope of steel, of corrosion products and of pumice mortars were performed. The following observations resulted from the experimental measurements: Reinforced lightweight mortar specimens with cement type CEM I 32.5 were less corroded than specimens with CEM II/B-M 32.5. Uncoated specimens were corroded to a greater extent, whereas all coatings appeared to be protective against corrosion of reinforcing steel. The acrylic dispersion coating presented the best protection level. Steel type S220 was less susceptible to corrosion than steel types S400 and S500s. The best corrosion resistance was present in specimens with the fine lightweight aggregate than in lightweight concrete specimens with medium and coarse pumice. The addition of LiF alone reduced corrosion of steel, whereas the addition of LiF and NaNO2 further reduced corrosion. Finally an inorganic silicate coating was used along with three different corrosion inhibitors that were either added to mortar or impregnated to the mortar surface. The addition of inhibitors inside the mass of the mortar always produced less corrosion than the impregnations and the inhibitor N-N’-dimethylaminoethanol gave the best results.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2016
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Pantazopoulou, Paraskevi
- Πανταζοπούλου, Παρασκευή
Subjects
dc:subject × 16- Διάβρωση οπλισμένου σκυροδέματος
- Προστασία οπλισμένου σκυροδέματος
- Ελαφροβαρές σκυρόδεμα
- Οργανικές επικαλύψεις
- Αναστολείς διάβρωσης
- Ανόργανες επικαλύψεις
- Corrosion of reinforced concrete
- Protection of reinforced concrete
- Lightweight concrete
- Organic coatings
- Corrosion inhibitors
- Ιnorganic coatings
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Χημικού Μηχανικού
- Engineering and Technology
- Chemical Engineering
Rights
dc:rights- Statement dc:rights
-
- BY_NC_ND
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/38312