Back to search

National Technical University of Athens (NTUA)

Αριστοποίηση μέτρησης της διαπερατότητας οξυγόνου σε πυκνές κεραμικές μεμβράνες με ιοντική αγωγιμότητα

Abstract

dc:description

One of the main properties of perovskite materials is their ability of oxygen separation which is facilitated through synergistic oxygen bulk diffusion and surface-exchange reactions mechanisms. Two main goals were achieved through this thesis a) the microstructural control through a novel preparation method with microwaves and b) analytical parameters for permeation measurements for each material category. In addition, experimental parameters such as feed and sweep flow rates at both sides of the membranes respectively were optimized for the best possible oxygen permeation fluxes calculations. Finally, a practically conventional measurement method was deployed towards the extrapolation of ionic conductivity values with electron blocking electrodes from SDC. These electrodes were produced on the surface of membranes by uniaxial pressing. In the present thesis three (3) main perovskite material categories have been studied (La0.8Sr0.2Mn0.5Fe0.5O3, BaFe0.85Cu0.15O3, BaFe0.85Ni0.15O3, Ba0.7La0.3FeO3). It was proved that the above parameters were depended on the compositions of each material as long as the preparation’s method microstructural results. Gas polarization effect described the phenomena for the above optimizations. Especially the composition BaFe0.85B0.15O3 resulted in an oxygen flux of 2.3 ml min-1 cm-2 at 800 oC and at oxygen partial pressure of 10-5 atm, value higher than relevant structures in literature. The above ionic conductivity method with electron blocking electrodes may successfully be used for the extrapolation of oxygen permeation fluxes until the value of 10-5 atm at the sweep side of the membrane. The highest values of ionic conductivity and oxygen permeation were achieved for the composition Ba0.7La0.3FeO3 (σION = 0.0041 S/cm and JO2 = 1.4 10-8 mol s-1 cm-2 at 800 oC and oxygen partial pressure of 10-5 atm). The microwave preparation route led to nanosized materials (green bodies) and after the final calcination temperature membranes with grains near 1.5 μm were acquired. Different values in oxygen permeation fluxes were attributed to the changes in critical radius from the doping effect of B-site cation of the perovskite leading to more free paths of oxygen ion mobility through the lattice. High oxygen fluxes were observed for La0.8Sr0.2Mn0.8Fe0.2O3 (LSMF8282) (2.3 ml min-1 cm-2 at 800 oC και and 10-5 atm) Stability experiments proved that this value remained stable even after 100h of continuous operation of the membranes. From preparation method, shaping procedure kai experimental parameters, the results led to elevated oxygen permeation values. The correlation of the critical value with intrinsic properties of the materials was obvious. Future usage of these materials in heterogeneous catalysis may show the same behavior of catalytic activity with the above properties.

Degree

thesis:*
Grantor dc:publisher
National Technical University of Athens (NTUA)
Year dc:date
2016

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Pandis, Pavlos
  • Πανδής, Παύλος

Subjects

dc:subject × 14

Rights

dc:rights
Statement dc:rights
  • BY
Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/38822

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Pandis, Pavlos; Πανδής, Παύλος. Αριστοποίηση μέτρησης της διαπερατότητας οξυγόνου σε πυκνές κεραμικές μεμβράνες με ιοντική αγωγιμότητα. National Technical University of Athens (NTUA), 2016. http://hdl.handle.net/10442/hedi/38822