National Technical University of Athens (NTUA)
Το πορώδες πυρίτιο ως υπόστρωμα για την ολοκλήρωση υψηλής απόδοσης παθητικών διατάξεων RF και κεραιών σε Si
Abstract
dc:descriptionIn the state-of-the-art technologies for integrated circuits, there is a gap between the standard complementary metal-oxide-semiconductor (CMOS) technology and the on-chip integration of high-performance radiofrequency (RF) analog devices (mainly passive ones) and antennas. Currently, most of the integrated RF systems are fabricated on III-V semiconductor substrates, which increases the fabrication cost of the entire system. Up to now, none of the solutions that have been proposed (e.g. passivated high-resistivity silicon-on-insulator wafers, proton bombardment) achieves to be at the same time effective, cheap and easily integrated within the CMOS processing. The bridging of this gap was the driving force of the research conducted within the framework of my PhD.Within this thesis, we investigated the advantages of porous silicon as a local substrate for the on-chip integration of RF passive devices and antennas. Porous silicon is a nanostructured form of Si, which can be easily formed by electrochemistry. In contrast to bulk Si, porous Si is a high-resistivity and low-permittivity material and its main advantage is that it can be locally formed on the Si wafer. The latter means that porous Si is formed only in the areas below the passive devices, while the rest of the wafer surface is left intact for the integration of CMOS electronics.Our first objective was to perform an accurate characterization of the PSi layers. Towards this, we have fabricated coplanar waveguides (CPWs) on several PSi layers and developed a method to extract analytically the dielectric parameters of the PSi layers. This method was applied in the frequency range 0–40 GHz and 140–210 GHz. We observed that the dielectric permittivity of the fabricated PSi layers was between 2 and 3.8, and its value was proven to be almost constant in both frequency ranges. The loss tangent, within the aforementioned frequency range, was around 0.03, presenting a slight tendency to decrease at higher frequencies. Using the extracted parameters of several PSi layers in commercial simulation software, we could reproduce the response of a variety of devices, as CPWs of different designs and inductors, a fact that proved the validity of our analytical method. Having characterized the PSi layer, we compared the performance of CPWs and inductors on PSi, with the performance of the ones fabricated on state-of-the-art substrates i.e. trap-rich high-resistivity Si (HR-Si) and quartz. We have to point-out that the trap-rich HR-Si substrate has been recently commercialized and is thought to be one of the best solutions for the integration of on-chip RF systems, up to now. Quartz is a standard high-performance off-chip substrate and it is used as a reference. We observed that porous silicon presents extremely low losses, lower than the ones of trap-rich HR- Si and comparable to quartz’s. This leads to reduced attenuation and increased quality factor of the CPW transmission lines, as well as to increased quality factor of the inductors. Especially in the case of the CPW transmission lines, the measured attenuation is one of the lowest ever achieved in CMOS compatible technologies. Moreover, we have shown that the very low relative permittivity of PSi reduces the capacitive coupling to the substrate, leading to reduced crosstalk between the devices and to increased operating frequency of the inductors. This property of PSi also allows the on-chip integration of low-loss, high characteristic impedance CPW transmission lines on the low resistivity CMOS substrate, a fact that is critical for the fabrication of high performance stepped-impedance filters.Extending the range of devices, porous silicon layers were used as substrates for the integration of miniaturized antennas, designed to operate at 50 GHz and 100 GHz. We observed that the use of porous Si reduced the substrate losses of the antennas and improved their performance, compared to standard antennas on CMOS Si. Through simulation analysis we could extract the necessary dimensions of the porous Si area, in order to achieve optimized performance of a thin film dipole antenna. The simulated optimized gain of this dipole antenna could be as high as 1 dBi, which is an excellent result compared to the literature.Conclusively, we believe that PSi can be a very competitive solution for the on-chip integration of passive RF devices with CMOS logic. The main achievement of this research was to enrich the characterization of porous Si layers, aiming to produce a reproducible and well characterized material that will be easily used by RF circuit designers. In parallel, we showed that PSi greatly reduces the losses of the RF passive devices (CPW, inductors). Finally, we integrated millimeter wave antennas on PSi for the first time, expanding the device toolbox that can be benefited by the use of porous Si.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2015
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Sarafis, Panagiotis
- Σαράφης, Παναγιώτης
Subjects
dc:subject × 22- Σύστημα σε ψηφίδα
- Πορώδες πυρίτιο
- Παθητικά στοιχεία
- Ραδιοσυχνότητες
- Χιλιοστομετρικά κύματα
- Ομοεπίπεδοι κυματοδηγοί
- Πηνία
- Ολοκληρωμένες κεραίες
- System-on-chip
- Porous silicon
- Passive devices
- RF
- Millimeter wave
- Coplanar waveguides
- Inductors
- Integrated antennas
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Ηλεκτρολόγου Μηχανικού, Ηλεκτρονικού Μηχανικού, Μηχανικού Η/Υ
- Νανοτεχνολογία
- Engineering and Technology
- Electrical Engineering, Electronic Engineering, Information Engineering
- Nano-Technology
Rights
dc:rights- Statement dc:rights
-
- BY_NC_ND
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/39046