University of Thessaly (UTH)
Size effects in semi-brittle materials and gradient theories with application to concrete
Abstract
dc:descriptionGiven the increasing awareness regarding the usefulness of gradient elasticity theories and the significant amount of theoretical work that has been produced in the last decade or so, it is rather surprising that the discussion concerning the relationship between the internal length and the material’s microstructure is more or less limited usually to the vague statement that the internal length parameter of the material is a function of the dominant feature of the material’s microstructure. The main aim of this thesis was to investigate the physical correlation of this internal length assumed by dipolar elasticity to the material’s microstructure. To the author’s knowledge, the estimation of an evolving internal length parameter for cementitious materials based on experimental evidence has not been done in the past. For this to be attempted and in order to investigate a possible size effect in elasticity from flexure tests of concrete beams, the two classical material constants, the Young’s modulus and Poisson’s ratio, should be determined independently. A homogenization procedure applied to heterogeneous materials in this study showed that the internal length is best described as a measure of the heterogeneity which cannot be defined only in terms of the dominant feature of the microstructure (size of inclusions) but also of the matrix/inclusions elastic mismatch in the material. This was verified experimentally by testing concrete specimens of various mixes with similar microstructural details but with different matrix/aggregate elastic mismatch. The internal length estimate determined based on this model was found to decrease with decreasing level of elastic mismatch. A gradient enhanced elasto-damage model applicable to the case of concrete beams under flexure, which relies heavily on the elasticity solution of the boundary value problem for the case of a dipolar elastic Timoshenko beam, is presented in this work. A closed-form solution of this problem and a methodology for solving more complex beam problems, such as indeterminate beam configurations, is described. This model reduces to the gradient Bernoulli-Euler solution and the classical Timoshenko solution if the necessary simplifications and limits are considered. The elasticity solution of the boundary value problem was used in conjunction with an assumed stress-strain law applicable to semi-brittle materials in order to produce numerical predictions for the inelastic response of the beams tested. The model proposed is shown to lead to an objective (mesh-independent) damage characterization. In this study, the presence of size effects in elasticity and inelasticity of cementitious materials was investigated based on midspan deflection and axial strain measurements of un-notched concrete beam specimens tested under true displacement-controlled 4-point bending for concrete with a compressive strength of up to 40 MPa. The geometrically similar un-notched beam specimens tested had a beam height to maximum aggregate size ratio of up to about 6.5. Since concrete possesses rather complex microstructural details due to the presence of different aggregate sizes with specific volume fractions (aggregate gradation), the internal length estimate for a given mix is compared with its average inclusion size, which describes its inherent heterogeneity. The average inclusion size for the concrete mixes considered in this study with a maximum aggregate size of 32 mm, obtained by mapping the actual microstructure on cross-sectional cuts of the specimens, ranged between 10 and 20 mm. An estimate of the internal length for a given concrete mix was obtained based on the applied load vs. midspan deflection and curvature measurements of the beam tests. A stiffer response than that predicted by the classical elasticity theory is measured in the flexural elastic response range of the beams tested. The proposed model predicted an internal length estimate of about mm in the case of the concrete mixes with a significant elastic mismatch for which cracking occurs predominantly in the matrix material (lower-strength concrete). It should be noted, that the same internal length estimate was obtained independently of the use of either the midspan deflection or the axial strain measurements. These concrete mixes are representative of a composite with inclusions much stiffer than the matrix material. It is important that the internal length parameter in this case appears to be practically equal to the average inclusion size of such a microstructure. On the other hand, lower internal length estimates of about and mm (about one-half the average inclusion size), were found for the two concrete mixes with a higher compressive strength. The lower internal length estimates for the higher-strength concrete is attributed to the lower elastic mismatch in the microstructure of these mixes, due to which a significant number of aggregates were fractured along the crack path. As expected, the size effect in elasticity is found to be insignificant in the case of the cement mortar mix with a maximum aggregate size of 1 mm, which can be viewed as a completely homogeneous material. Furthermore, it is argued that microcracking in semi-brittle materials, which is the source of material softening, should also affect the initial internal length parameter value, g0, which is associated with the given heterogeneity of the material. If a microstructural internal length is related to the level of damage, a thermodynamic formulation of the problem showed that this length should be either increasing or remaining constant with damage. An experimental investigation of the particular form of the gradient internal length evolution law verified this theoretical finding since it was shown that an increasing gradient internal length with damage yields non-local predictions that are in better agreement with the experimental results than the local predictions. Finally, a non-linear (exponential) relationship between damage and the gradient internal length was found to satisfy the objectivity requirement of a size-independent internal length evolution law for the cementicious mixes considered in this study. Also, it was found that the rate of increase in the internal length value with damage is increasing with increasing brittleness level of response.
Degree
thesis:*- Grantor dc:publisher
- University of Thessaly (UTH)
- Year dc:date
- 2016
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Triantafyllou, Antonios
- Τριανταφύλλου, Αντώνιος
Subjects
dc:subject × 6Rights
- Language dc:language
- eng
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/39810