National and Kapodistrian University of Athens
Συγκριτική μελέτη της συγκολλήσεως με την οδοντίνη τεσσάρων νέων εμφρακτικών υλικών: μελέτη In Vitro
Abstract
dc:descriptionThe purpose of this investigation was to examine the bonding properties of three restorative materials, recommended for the restoration of cervical erosion lesions, and polycarboxylate cement, with dentine, after various treatments of its surface.The materials used were: a) Glass ionomer cements: 1.Caulk – Aspa Caps glass ionomer restorative (The L.K. Caulk Company), 2. Fuji ionomer Type II (G.C Dental Industrial Corp., Japan) b) Composite resin: Cervident (S.S. White, Philadelphia), in powder – liquid form with coupling agent, c) Polycarboxylate cement: Durelon (ESPE GmbH, Germany).Four different agents were used in order to change the surface characteristics: (A) Citric acid solution 50% for 30 seconds, (B) EDTA solution 17% for 60seconds, (C) Phosphoric acid solution 50% for 60 seconds, (D) Remineralizing solution prepared as recommended by Levine, Beech and Garton. Flat dentine surfaces of non-carious human teeth were used. A tubular stainless steel holder was filled with the material under test and centered on to the exposed dentine area. The holder was the loaded with a brass weight and the assembly was allowed to set for 15 minutes at room temperature. The bonded assembly was the removed from the alignment jig and stored in water 37o C in a humidifier for 24 hours until testing. The test was performed using an Instron testing machine. The tensile load required to cause fracture was recorded using a crosshead speed of 0.5 cm per minute. After the fracture of the bond the surfaces of dentine and the bonded material were prepared for Scanning electron microscopy.Results 1) Both glass ionomer cements showed good bonding with the untreated dentine. ASPA bonding improved by citric acid pre- treatment while the bonding of the Fuji was improved after pre-treatment of the dentine surface with EDTA solution. 2) The use of the remineralizing solution didn’t affect the bonding of the glass ionomer cement to dentine. 3) The best bonding with untreated dentine was obtained by the polycarboxylate cement, with further improvement by the use of the remineralizing solution. On the other hand the bonding of the polycarboxylate cement was reduced after treatment of the dentine surface with citric acid solution. 4)Although Cervident showed no or very low bonding with dentine untreated or treated with phosphoric acid, the use of the promoter increased dramatically the bonding of the material.By the SEM examination all the materials showed penetration into the open tubules after the use of the acid etchants. Bonding of the polycarboxylate cement with dentine is a result of adhesive forces, on the contrary glass ionomer cements and composite resins after the use of the promoter, achieve adhesion in addition to michromechanical interlocking by tubular penetration.
Degree
thesis:*- Grantor dc:publisher
- National and Kapodistrian University of Athens
- Year dc:date
- 1978
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Vougiouklakis, George
- Βουγιουκλάκης, Γεώργιος
Subjects
dc:subject × 17- Συγκόλληση στην οδοντίνη
- Εμφρακτικά υλικά
- Υαλοιονομερείς κονίες
- Πολυκαρβοξυλική κονία
- Αντοχή στον εφελκυσμό
- Dentine bonding
- Restorative materials
- Glass ionomer cements
- Polycarboxylate cement
- Composite resin
- Tensile bond strength
- Ιατρική και Επιστήμες Υγείας
- Επιστήμες Υγείας
- Ιατρική Βιοτεχνολογία
- Medical and Health Sciences
- Health Sciences
- Medical Biotechnology
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/40490