National and Kapodistrian University of Athens
Μελέτη ποζολανικών υλικών βιογενούς και ηφαιστειακής προελεύσεως: παράγοντες που επηρεάζουν την ανάπτυξη αντοχών στο τσιμέντο
Abstract
dc:descriptionΤhe aim of the present investigation was to determine the effect of biogenic silica and igneous rocks on the strength development of cement and to compare the characteristics of the reactive silica originating from different sources with respect to the various rock formations. According to European regulations, the amount of reactive silica in a raw material evaluated as pozzolana should exceed 25% of its mass. Natural pozzolanas include those igneous or sedimentary rocks that besides the amorphous, glassy phase might contain amorphous silica (opal-A), opal CT occurring as nanocrystalline silica and minerals of the zeolite family. These are the minerals that are generally accepted as the main sources of reactive silica that plays a considerable role in the strength development of pozzolanic cements. Ιn the present study the role and importance of the most common minerals comprising part of the pozzolanic rocks such as clays, quartz and feldspars was evaluated. These minerals are considered non-reactive in general, therefor etheir presence in raw materials intended for use as pozzolanic additives is not desired. Nevertheless, as inferred by the present study, that assumption might not be entirely true with their role in the overall strength development during hydration of pozzolanic cements being the least to say ambiguous, as the issue of quartz indicated.The experimental procedure followed in the present investigation was focused on the following three issues:• Collection and examination of samples from a wide range of rock formations including all of those considered as pozzolanas together with samples from formations other than those of the typical pozzolanas.• Characterization of all the above mentioned samples focusing on their chemical and mineralogical composition. Additional techniques, methods and instruments such as optical and scanning electron microscopy, FTIR, DTA and Chapelle were implemented for the evaluation of their reactivity. Emphasis was given to the determination and evaluation of the reactive silica (measured according to EN 197-1) that was determined in all materials.• Production of laboratory cements by cogrinding clinker, gypsum and pozzolana and their evaluation based on late strength. The produced cements were divided into categories according to the kind of pozzolanas implemented in their production and the late strength (28-day) was estimated with the help of specific surface and reactive SiO2 content of pozzolana. This approach had been tried out in the past but it had not taken into consideration the different nature of each pozzolana in order to evaluate the cement according to the implemented pozzolana. Therefore, differences in the behaviour of pozzolanic cements could be attributed to the distinctive origin of reactive SiO2 which, along with specific surface, could relate late strength to these two aforementioned parameters. As concluded in the presentin vestigation, the results showed a satisfactory prediction of late strength that could possibly improve by implementation of additional parameters (e.g. water demand,setting time, grain size distribution, etc.). In conclusion, the main outcomes of the present investigation could be summarized as follows:• A preliminary assessment of the pozzolanic reactivity, according to the pozzolanic family that a raw material belongs with emphasis on its mineralogical composition, ispossible. The effect of the geological origin of the pozzolanas on the properties of the respective cements was evident emphasizing the important role that geology plays in the evaluation of pozzolanic materials.• The preliminary evaluation of pozzolanic reactivity requires first of all the geologist assessment who has to characterize the rock formations that the samples were originated from and to choose those seeming promising. Following that and taking the chemical and mineralogical analyses into consideration some conclusions and probable/expected values of reactive silica could be inferred leading to those candidates with the most favourable characteristics.• Optical microscopy comes to play an important role in the overall quality of the examined materials but it lacks the potential for quantification of the observed parameters.• Scanning electron microscope could provide important information regarding the nature and origin of reactive silica (e.g. diatoms), the individual size of the particles and the degree of diagenesis. Therefore, two diatomite rocks of a different origin containing a similar amount of reactive silica might behave differently when used for the manufacturing of cement and concrete depending to their size, shape, purity and inclusions of other siliceous minerals. All of the above could significantly affect the development of the microporosity and the strength of the final product due to the great impact that could have on the specific surface. Furthermore, the microanalysis capability of the SEM constitutes a powerful tool that could be used for the identification of various crystal minerals and the determination of the chemical composition of the amorphous/glassy phases, a parameter that greatly affects pozzolanic reactivity.• Differential thermal analysis could be used to determine compounds that are inactive and to supply information regarding quality and quantity characteristics of the samples. As shown in the respective chapter, every pozzolana family could be characterized by a special ‘’footprint’’ that can be used for their evaluation.• FTIR spectroscopy is fast, does not require time consuming preparation of the sample besides fine grinding and could yield a preliminary assessment of pozzolanic reactivity with limitations analyzed in detail in the respective paragraph that mainly regard peak overlapping. Therefore, a more extensive and in depth research is required that could include a substantial number of samples covering the major pozzolanic groups and involve additional, if possible, advanced instrumentation (e.g.NMR). Furthermore, it could be quite helpful to extend that research into hydrated cementiteous products in an attempt to correlate the outcome of the implementation of the various techniques, especially to those of FTIR spectroscopy. Regarding quartz, that constitutes a large part of the rock formations on the earth surface, thus found in the majority of rocks, it was found that:• The grain size of the quartz contained in the ground pozzolana used for cement production plays an important role on its activation and reactivity. To be morespecific, quartz grains of large size are generally non-reactive and do not contributein the pozzolanic reaction. On the contrary, as the quartz grain size gets smaller its overall reactivity increases. That comes into terms with the results of previous reports where the quartz particle size in the 10-12 μm range was found critical for its reactivity. In addition, further decrease in the particle size did not seem to drastically improve the reactivity of the crystalline silica.• Another important parameter generally overlooked could be the degree of crystallinity of the quartz crystals contained in the pozzolanic rock. In that case,crystalline SiO2 mineralogically identified as a-quartz, could contribute considerableportion to reactive silica if it exists in the crypto- or microcrystalline form, depending on its forming process. Microcrystalline quartz includes varieties consisting of very small, optically distinguished by the optical microscope crystals, where as the structure of the cryptocrystalline silica is not visible by the same means.• A pozzolana or a rock formation assessed as pozzolana and consisting to a large degree by crystalline quartz -thus rejected due to its assumed in activity-requires amore careful scrutiny in order to evaluate its reactivity with respect to crystal size and form along with its reactivity. That could expand the range of rock formations considered as pozzolanas and as such exploit areas and quarry wastes that other wisewould be piled up having a considerable environmental impact, remain unexploited and increase the overall cost of the material. Presently, the evaluation of a raw material as pozzolana by the cement companies is based on its reactive SiO2 content, that is determined by a time-consuming wet chemical method. A number of outcomes from the present investigation might help in the selection of higher quality pozzolanas and make the process of pozzolana evaluation faster:• Evaluation of pozzolanas based exclusively on reactive SiO2 content is inadequate. The reactive SiO2 content as mentioned in the ΕΝ 197-1 cannot deliver the fullpotential of pozzolana reactivity and as such does not suffice for the evaluation of materials as pozzolanic additives for cement production. As shown in the presentstudy, natural pozzolanas with similar content of reactive SiO2 when added in the cement might have a different effect on its properties. To fully evaluate pozzolanic materials, chemical and mineralogical analyses should be carried out, as well,together with the production of laboratory cements. The need for additional testing resulted from the correlation between reactive SiO2 with the chemical and mineralogical analyses that differed for every pozzolanic group. Furthermore, correlations derived by each pozzolanic group were improved compared to those that resulted from the implementation of all pozzolanic materials (prior tocategorization). However, to fully evaluate natural pozzolanic materials, production of laboratory cements with the pozzolana under investigation should also be carried out.• Reactive SiO2 from pozzolanas of biogenic origin appears to be more reactive than that of the rest. However, the former are easier to grind than the latter resulting to cements with increased specific surface, which is factor positively affecting cement strength, especially the early one. Unfortunately, their higher specific surface increases water demand, thus increasing in turn the need for superplasticizers in order to minimize water addition that has a negative impact on strength. Comparison of test results between Chapelle and reactive SiO2 content showed satisfactory but not utter correlation. The results were improved when separate pozzolanic families were considered pointing out to the effect of geology on pozzolana reactivity.• Reactive SiO2 and specific surface could be used for an estimation of late strength (28-day) of the composite cements. Prior to that, characterization and categorization of the pozzolana being evaluated is required. Furthermore, in addition to reactive SiO2 and specific surface, a number of other parameters such as water demand, setting time, early strength (1- and 2-day) and specific microstructure characteristics during early hydration could improve the 28-day strength prediction.
Degree
thesis:*- Grantor dc:publisher
- National and Kapodistrian University of Athens
- Year dc:date
- 2016
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Fragkoulis, Dimitrios
- Φραγκούλης, Δημήτριος
Subjects
dc:subject × 14Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/44201