National Technical University of Athens (NTUA)
Χαρακτηρισμός της απόδοσης του ανιχνευτή Micromegas για την αναβάθμιση New Small Wheel και ανάπτυξη και βελτίωση του συστήματος αυτομάτου ελέγχου των ανιχνευτών μιονίων στο πείραμα ATLAS
Abstract
dc:descriptionThe upgrade of the ATLAS muon spectrometer is primarily motivated by the high background radiation expected during Run-3 (2021) and ultimately at in HL-LHC (2026). Owing to this the detectors that occupy the innermost muon station called Small Wheel (SW), MDT, CSC \& TGC, will go beyond their design luminosity limit. In addition, the muon trigger rate will exceed the available bandwidth because of the fake endcap muon triggers (90% is coming from low energy particles, generated in the material located between the Small Wheel and the outer endcap muon station). The collaboration has decided to replace the SW with a NSW system combining sTGC & resistive MM detectors in order to maintain the excellent performance of the muon system beyond Run-2. Both detector technologies should provide tracking and triggering information for redundancy. The NSW will contribute to the suppression of fake triggers by reconstructing high quality (σ~1mrad) IP pointing segments online. Moreover, efficient \& precise offline tracking (σ~100μm) even for the maximum expected rate of (15kHz/(cm2) is required. The NSW requires fully efficient high-rate capable MM chambers with a single plane spatial resolution better than 100μm independent of the track incidence angle and the magnetic field (B<0.3T). Along with the precise tracking the MM should be able to provide a trigger signal, complementary to the sTGC, thus a decent timing resolution is required. The studies focus on the efficiency as well as hit and time reconstruction accuracy measured during these tests demonstrating the excellent characteristics of the MM. Moreover, owing to the moderate magnetic field expected in the NSW region, dedicated studies have been devoted in understanding the effect of the Lorentz force on the MM performance when operated inside a magnetic field. The effect of the field has been well understood using test beams, with chambers operated inside magnets, and in simulation. Owing to the quantitative agreement between simulation and test beam measurements the exact knowledge of the magnetic field value has become a prerequisite for a precise track reconstruction in the NSW Micromegas in order to correct for the field effect. Complementary to studying and optimising the MM performance, the use of readout geometries with different characteristics had been studied. The adoption of these schemes for the MM readout minimise the number of detection layers and electronic channels, decreasing the complexity, and make the application of Micromegas in large scale experiments feasible. The use of a stereo readout scheme, as foreseen for the NSW MM, allows for a two-dimensional hit position reconstruction with a decent accuracy. The validation of the stereo principle has been performed studying a medium size quadruplet prototype MM, following the NSW stereo readout scheme. Moreover, the possibility of multiplexing MM strips into a smaller number of electronic channels has been studied. The results demonstrate the feasibility of the multiplexing concept, proving that the excellent intrinsic characteristics of the detector remain unaffected by the multiplexing that significantly reduces the number of electronics channels.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2016
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Ntekas, Konstantinos
- Ντέκας, Κωνσταντίνος
Subjects
dc:subject × 18Rights
dc:rights- Statement dc:rights
-
- BY_NC_ND
- Language dc:language
- eng
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/46473