Back to search

Democritus University of Thrace (DUTH)

Microring resonator design with application to performance improvement of optically and electrically modulated semiconductor optical amplifier

Abstract

dc:description

In recent years there has been intense research interest in using Semiconductor Optical Amplifiers (SOAs) for signal amplification and encoding in fiber optic communication systems and networks. In optical modulation, SOAs are used as booster amplifiers, as in-line amplifiers, and as pre-amplifiers. However, these applications are limited by the SOA finite carrier lifetime and consequently their irregular gain saturation which causes the pattern effect, where the amplified data are distorted. In electrical modulation, SOAs are used as intensity modulators, through their direct modulation of their current, in applications such as radio over fiber and broadband passive optical access networks. However, the SOA’s modulation bandwidth is limited to 2.5 GHz and therefore cannot support the high data rates of these applications. To address this problem in both cases of SOA operation, this dissertation proposed, investigated, and demonstrated the use of a single microring resonator (MRR) as an optical notch filter. After the identification of the necessary conditions which must be satisfied so that the MRR acts as notch filter, the technological feasible criteria for design the MRR with regard to its radius have been specified and these have been applied to significantly improve the pattern-dependent SOA performance as well as the quality characteristics of the amplified or encoded signal. Then, for the first time, through numerical simulations, has been demonstrated that using a passive single MRR allows to directly modulate a conventional SOA at 10 Gb/s, which is a fourfold increase of the rate at which it is possible to modulate a SOA due to its finite carrier lifetime. Concurrently, small-signal analysis is conducted, which for the first time correlated the power perturbations of the modulated signal at the SOA output with those at the MRR output, thus confirming the extension of the electrical bandwidth of the SOA-MRR combination. Afterwards, a thorough comparison of the MRR against the Optical Delay Interferometer (ODI) has been realized, which constitutes a popular alternative architecture for optical notch filter implementation. For this purpose, a rational procedure of equivalent comparison based on the slope of the spectral response of each filter in relation to the mechanism of pattern effect suppression in a SOA configured as linear amplifier has been formulated and applied. The quantitative comparison which is realized using this methodology, leaded to the conclusion that the MRR achieves better performance than the ODI for the majority of defined metrics, which combined with the MRR inherent advantages can render the latter preferable over the conventional options that are available for the same purpose. Finally, has been shown for the first time the feasibility of using a single MRR as notch filter for allowing the direct modulation of a Reflective Semiconductor Optical Amplifier (RSOA) by more than three times higher data rate than being possible with the RSOA alone. Using small-signal analysis is extracted an analytical expression for the modulation response of a RSOA when driven by a digital encoding modulation current of rectangular waveform, which had never done before for such a practical case. The combination of this response with that of an MRR of appropriate radius and detuning, has shown that owing to the MRR the RSOA finite modulation bandwidth can be extended to a degree that the RSOA performance is not limited by the pattern effect. Lastly, has been derived in analytical form the instantaneous frequency deviation (chirp) at the MRR output, thus allowing the precise calculation of this measurand whose compensation is critical for restoring the encoded pulses quality. This till recently was not possible due to the abrupt variation of the MRR phase response, whose rate of change defines the chirp, around MRR resonance which coincides with the notch of the MRR spectral response.

Degree

thesis:*
Grantor dc:publisher
Democritus University of Thrace (DUTH)
Year dc:date
2020

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Rizou, Zoe
  • Ρίζου, Ζωή

Subjects

dc:subject × 16

Rights

dc:rights
Statement dc:rights
  • BY_NC_SA
Language dc:language
eng

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/47157

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Rizou, Zoe; Ρίζου, Ζωή. Microring resonator design with application to performance improvement of optically and electrically modulated semiconductor optical amplifier. Democritus University of Thrace (DUTH), 2020. http://hdl.handle.net/10442/hedi/47157