Back to search

National Technical University of Athens (NTUA)

Ηλεκτρολυτική συν-απόθεση υβριδικών σωματιδίων με βάση τον άνθρακα σε μήτρα νικελίου

Abstract

dc:description

In the present PhD thesis, nickel metal matrix composites reinforced with hybrid particles MWCNTs-μAl2O3, MWCNTs-SiC and Graphene nano Platelets GnPs, were produced by electrodeposition from a Watts type bath. During deposition a rotation disk electrode was used (ω= 400 rpm), and both direct (DC) and pulse current (PC) was applied. The effect of the imposition of different frequencies of current pulses (ν= 0.1 up to 1000 Hz) as well as the presence of the anionic surfactant Sodium Dodecyl Sulfate (SDS) on the structure, the morphology and the percentage of the embedding particles on the nickel metal matrix of the composite coatings, was investigated. Moreover, pure nickel coatings, under the same electrodeposition conditions were also produced for comparison reasons. Regarding the composites Ni/MWCNTs-Al2O3, the results indicated that the imposition of direct currect, in absence of SDS, was accompanied by the dominace of [100] crystalline texture, while the presence of SDS, or the imposition of pulse current, resulted in a random orientation of nickel crystallites. It was found that the surface morphology of the composite coatings was characterized by an open-like porous structure. However, the coatings were compact acroos the cross section with a uniform despersion of the hybrid particles in the metal matrix, which was verified by Raman spectroscopy measurments. Raman spectroscopic analysis was revealed that in the absence of SDS, the hybrid particles MWCNT-Al2O3 were characterized with a high degree of structural disorder, indicating an increased agglomeration degree of the embedded particles in the Ni matrix. By applying the technique of linear sweep voltammetry in combination with electrochemical impedance spectroscopy and quartz crystal microbalance, a possible mechanism for the electrodeposition of the hybrid particles in the nickel metal matrix was proposed: Due to the large active surface and the low overpotential of hydrogen reduction on the surface of MWCNTs-Al2O3, an increase of the proton reduction rate was observed. However, the rate of hydrogen evolution was reduced in presence of SDS, possibly due to the adsorption of SDS molecules on MWCNT-Al2O3 sites resulting to the reduction of the number of available sites for rapid hydrogen evolution. In the case of composites Ni/MWCNTs-μSiC, by imposition of direct current in absence or presence of SDS, it was observed that it does not disturb the initial nickel crystallographic line [100]. Under the imposition of high frequency pulse current, random orientation prevailed. Therefore, the hybrid particles MWCNTs/μ-SiC, seems to perturbed the nickel crystal growth in such an extent by increasing the number of nucleation sites that a random orientation is induced. The study of the surface morphology of the composite coatings revealed a compact structure. Raman spectra on the surface of the composite coatings indicated that the presence of SDS in the electrolytic bath led to a more uniform dispersion of the hybrid particles in the NI matrix without inducing a considerable disorder in the structure of the carbon nanotubes. Under direct current and in the presence of GnPs in the electrolytic bath, the texture [100] remained similar to the case of pure nickel coatings. Under pulse current, by increasing gradually the pulse frequency values and for concentration equal to 0.1 g/L GnPs, in absence of SDS, the same sequence of preferred crystalline structure was observed [100]→[211]→[110], similar to that of pure nickel composites. In the presence of SDS the sequence [100]→[R]→[211]→[111+110] was observed. By increasing the concentration of GnPs in the electrolytic bath up to 0.5 g/L, in presence of SDS, the sequence: [100]→[110] was revealed. The surface morphology of the composite coatings was rather compact characterized by the presence of «bumps» near the region of embedded graphene platelets. Raman spectra study revealed that the imposition of high frequency pulse current led to enhanced structural disturbance of the graphene platelets during co-deposition with the Ni matrix, which was attributed to the “wrinkling” of the graphene sheets. For the case of pure nickel composite, micro hardness measurements demonstrated that the presence of SDS did not facilitated the micro hardness values. it turned out. In the case of Ni/ MWCNTs-Al2O3 composite coatings the simultaneous presence of SDS in the electrolytic bath in combination with the imposition of pulse current resulted in an increase of micro hardness values. The imposition of pulse current led to the increase of micro hardness values as in the case of Ni/GnPs composites. The higher micro hardness values were recorded in the case of composite coatings Ni/GnPs (0.1 gL-1), that were produced in absence of SDS and under medium or high pulse current frequencies (ν=10, 100 Hz), which could be attributed to the high percentage of co-deposited particles in the nickel matrix. Finally, an increase of the micro hardness values was observed also for the case of Ni/MWCNTs-SiC composite coatings. The evaluation of the dry ball-on disc tests demonstrated that incorporation of carbon based particles in the nickel metal matrix resulted in the reduction of cof values compared to pure nickel ones, while the simultaneous presence of SDS in the electrolytic bath led to further reduction of those values. Thus, the composites Ni/MWCNTs-SiC produced in presence SDS exhibited the lower friction coefficient value and wear track width, indicating less wear due to dry sliding friction. Moreover, it was found that for all the tested composite coatings, the overall wear mechanism can be characterized by an adhesion, oxidation and abrasion wear mechanism. The corrosion resistance study showed that Ni/MWCNTs-Al2O3 coatings prepared in the absence of additive and by Pulse Current imposition (ν=100 Hz), exhibited the lowest polarization resistance value compared to the other composite coatings studied, while their electrochemical characteristics remaining unaltered during their immersion (60 h) in NaCl solution, which is mainly attributed to their particular surface morphology.

Degree

thesis:*
Grantor dc:publisher
National Technical University of Athens (NTUA)
Year dc:date
2020

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Chronopoulou, Nikoletta
  • Χρονοπούλου, Νικολέττα

Subjects

dc:subject × 8

Rights

dc:rights
Statement dc:rights
  • BY_NC_ND
Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/47579

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Chronopoulou, Nikoletta; Χρονοπούλου, Νικολέττα. Ηλεκτρολυτική συν-απόθεση υβριδικών σωματιδίων με βάση τον άνθρακα σε μήτρα νικελίου. National Technical University of Athens (NTUA), 2020. http://hdl.handle.net/10442/hedi/47579