Back to search

University of Patras

Επίδραση της μικροδομής στη μηχανική συμπεριφορά των ψαμμιτών

Abstract

dc:description

The aim of this thesis is the determination of the physical, mechanical and petrographic properties of sedimentary (clastic and chemical) intact rocks and the correlation between them. The research focused on sedimentary rocks, mainly clastic (submarine fans (Flysch) sandstones), Neogene Pleistocene sediments (coherent sand and silt) and chemical (limestones).An extensive program of laboratory tests of Rock Engineering was conducted at the Laboratory of Engineering Geology of the University of Patras, on selected sedimentary intact rocks obtained from 52 different sites of Greece. Physical and mechanical properties were determined, while the investigation was focused on strength parameters determination of intact rock and especially on uniaxial compressive strength (σci), as well as to the Hoek-Brown strength parameter mi which calculated through special triaxial compression tests. Triaxial tests were performed at each selected sampling site and always in accordance with the existing ISRM and ASTM standards.The results of the laboratory tests showed that the clastic sedimentary rocks present higher values of porosity, void index and void ratio, while the chemical sedimentary rocks showed the highest dry and saturated density. In addition, the clastic sediments rocks showed lower values at the sound velocities Vp and Vs compared to the chemical sedimentary rocks.Significant variation was recorded in the strength parameters (uniaxial compressive strength, point load index, SHV hardness) of the examined rocks, due to the different lithological composition and structure, matrix material, etc. Analysis of the petrographic parameters (structure and chemistry) and fabric parameters (morphology, mineral grain contacts and presence of pores) using scanning electron microscope (SEM) showed a strong interdependence between them and the strength of the rock material. The "constant" mi determined by triaxial tests showed a significant range of values for the two main rock categories. The calculated average values appear higher mainly for the sandstones compared to the literature suggested by Hoek (2007). The strong dispersion of the values in the same petrographic rock type showed that the “constant” mi depends on the petrographic characteristics of the material (grain interlocking, percentage of matrix material, etc.).In addition, the mineralogical composition and microstructure of the rocks (size, shape and interlocking of the grains) were determined by examining characteristic thin sections under a polarizing microscope. The microstructure of rock material was quantified through the calculation of internationally accepted petrographic indices, and specifically PD (Packing Density), GC (Grain Contact), GAR (Grain Area Ratio) and PCC (Consolidation Factor). The processing and statistical analysis of the laboratory results showed that there is a strong effect of "microstructure", as quantitatively described by the petrographic indices, on the values of the parameter mi, while this is not recorded for the uniaxial compressive strength (σci). The value of parameter mi increases with increasing grain size in the sandstones, while decreases with increasing matrix material. As a result, the fine - grained members of the clastic rocks (siltstones, clays, etc.) have lower values of the constant mi than the sandstones. Also, in clastic rocks, the "constant" mi increases with the increase in the value of petrographic indices, which seem to be the dominant factors in the configuration of its values. In contrast, in limestones it decreases significantly with the increase of sparitic material and this is opposite to those given by proposed values of Hoek (2007). These changes in the values of “constant” mi, result in a significant differentiation of the estimated mechanical parameters of the rock mass (strength, deformability), up to ± 50%, as shown by the comparative view of the Geological Index GSI in 52 research sites . This fact shows that the requirement for a reliable estimate of the “constant” mi is an important factor in proper design.

Degree

thesis:*
Grantor dc:publisher
University of Patras
Year dc:date
2020

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Ktena, Stella
  • Κτενά, Στέλλα

Subjects

dc:subject × 14

Rights

dc:rights
Statement dc:rights
  • BY
Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/48643

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Ktena, Stella; Κτενά, Στέλλα. Επίδραση της μικροδομής στη μηχανική συμπεριφορά των ψαμμιτών. University of Patras, 2020. http://hdl.handle.net/10442/hedi/48643