Back to search

Aristotle University Of Thessaloniki (AUTH)

Η επίδραση της χρονικά μεταβαλλόμενης ταχύτητας διάτμησης στην παραμένουσα αντοχή του εδάφους

Abstract

dc:description

The subject of the thesis is the investigation of time dependent rates of displacement on the residual strength of soil.Residual strength represents the minimum constant strength of soil mobilized at large displacements and is required in the solution of large displacements problems in soil mechanics, such as slope stability, landslides and displacement piles. More specifically, its knowledge is required in the case of presence of pre-existing shear zones in the soil, due to previous movements, or reactivated landslides, or tectonic forces, as well as in the case of soils exhibiting progressive failure.Almost all previous laboratory investigations on the effect of rate of displacement on the residual strength of soil have shown that whereas small rates of displacement (lower than 1mm/min) have little effect on the residual strength, large rates of displacement have a great influence on it. In particular, three type of displacement rate effect on the residual strength have been established: positive, neutral and negative, when an increase, negligible increase and a decrease in residual strength at fast rates of displacement is observed, compared to the slow residual strength of the soils at slow drained rate of displacement. All the investigations concerning the effect of rate of displacement on the residual strength have considered constant in time rates of displacement, a hypothesis that is not in agreement with the kinematics of landslides in nature, during which phases of accelerating, constant velocity and decelerating movements may be observed. Recent investigation on the behavior of soils with negative rate effect during fast shearing, have shown that their behavior depends not only on the rate of displacement, but on its change with time, the acceleration (Papadopoulos, 2014). Therefore, the realistic analysis of the kinematics of landslides requires the knowledge of the effect of both rate of displacement acceleration on the residual strength of soil. In order to investigate these effects a laboratory investigation conducted mainly by means of ring shear tests on natural soils and artificial mixtures was performed in the context of this thesis.The thesis comprises eight chapters and four appendices (A, B, C and D).Chapter 1 is an introduction to the thesis, in which the subject, the tasks, as well its structure is presented.Chapter 2 presents a literature review on the mobilization of the residual strength, the shear modes at the residual state at slow drained rates of displacement, as well as the effect of rate of displacement and acceleration on the residual strength. Chapter 3 describes in detail the laboratory techniques used in the research. Particular emphasis is placed on the description of the ring shear apparatus installed at the Laboratory of Soil Mechanics, Foundations and Geotechnical Earthquake Engineering at Aristotle University of Thessaloniki and its various parts, including the servocontroller used for the selection and the control of the rate of displacement and its variation with time (accelerating, constant velocity and deaccelerating movement), The sample preparation and testing procedures, as well as the calculation and presentation of results are also described. According to the standard shearing procedure, after the mobilization of the slow drained residual strength, the specimens were subjecting in a sequence of alternating stages of fast and slow shearing. For the investigation of the effect of both rate of displacement and acceleration on the residual strength three type of time histories of rates of displacement were used, mainly by controlling the duration of the accelerating movement, tac, the constant rate of displacement movement, tcv, and the deaccelerating movement until its ceasation, tdec: Type I (≤10mm/min, tac≥0.15s), Type II1 (>10mm/min, tac=0.15s), and Type II2 (>10mm/min, tac>0.15s). Then, the procedure for other laboratory tests used in the research, such as shear box and classification (liquid and plastic limit, grading analysis) tests is presented. Finally the techniques used for the observation of the microstructure of the soils, such as thin section observation under camera and optical microscope, electron microscopy, mercury porosimeter and microtomography are described. Chapter 4 presents the tested soils, as well as the programme of the laboratory tests conducted. A flysch, a clean sand (M31) and bentonite, as well as artificial mixtures were used in order to investigate the effect of both the rate of displacement and the acceleration on the residual strength of soils with the same mineralogy, but different physical properties. The artificial mixtures we prepared by mixing a coarse and a fine material in different proportions, so that they are well graded, as natural soils ususally are. The coarse material was a mixture of the clean sand (M31) and a silty sand (D6) at a weight percentage of 20% and 80% respectively. The fine material was prepared by mixing kaolin and bentonite at a weight percentage of 30% and 70% respectively. Three artificial mixtures were tested by mixing the above described coarse ( C) and fine (F) materials at various weight percentages: C/F: 70/30, 40/60 and 0/100. Twenty seven ring shear tests were conducted in total at a normal stress ranging from 120kPa to 480kPa. The effect of rate of displacement on the residual strength of the soils was investigated in all the tested soils by conducting shearing at fast rates of displacement (Types I and II1, tac=0.15s). To investigate the effect of acceleration, shearing at fast rates of displacement with different tac but the same final value was performed (Types I and II2, tac>0.15s). The effect of acceleration was investigated in the flysch and the artificial mixtures 70/30 and 40/60. Finally, the programme of the shear box tests, conducted for the determination of the critical strength of the soils is presented.Chapter 5 presents the analysis of the ring shear and shear box tests results. For each tested soil, the shearing mode at the slow drained residual state, the variation of the drained coefficient of friction at the residual state with normal stress, as well as the critical and drained residual strengths envelopes are presented. Then the results concerning the effect of varying rates of displacement are presented (Types I and II1, tac=0.15s). In particular the variation of the following characteristic strengths with the rate of displacement is presented: the immediate fast, the fast peak, the fast residual and the slow peak strength after fast shearing. Then, the effect of acceleration on the residual strength during fast shearing is presented for flysch, and artificial mixtiures 70/30 and 40/60. Finally, the results from the study of the microstructure of the artificial mixtures 70/30 and 40/60, developed during fast shearing, are described.Chapter 6 presents initially the tests difficulties, associated with ring shear testing due to soil loss through the gap during shearing, as well as the analysis of the ring shear and shear box results concerning the characteristics strengths and the main influencing factors affecting them is presented. For the slow drained residual strength, these parameters are the effective normal stress, the intergranular void ratio, representing the relative proportions of the fine to coarse material, the mineralogy, the grading, as well as the physical properties of the soils (Liquid, Limit, Plasticity Index and Clay Fraction). For the immediate fast and fast peak strengths, the main parameters and the instantenous rate of diasplacement and the normal stress. The most important factors affecting the fast residual strength are the rate of displacement, the acceleration and the possibility of water infiltration into the shear zone during fast shearing.In the case that water infiltration is allowed into the shear zone (water in the bath), three types of variation of residual strength with rate of displacement are defined for the tested soils (Types I and II1, tac=0.15s).-Type A, at low to intermediates rates of displacement the fast residual strength is either constant and equal to the slow drained residual strength, or exhibits a small reduction (up to 20%) at rates of displacement exceeding 100mm/min and up to 2500mm/min,-Type B, the fast residual strength exhibits a small reduction (up to 20%), as compared to the slow drained residual strength, at rates of displacement exceeding 0.01mm/min and up to 2500mm/min.-Type C, the fast residual initially up to a critical rate of displacement (Range 1) is either above, or equal, or below the slow drained residual strength. For rates of displacement exceeding the critical value, the fast residual strength shows a significant drop below the slow drained residual strength (negative rate effect, Range 2). Type C was observed for rates of displacement excedding 0.01mm/min and up to 2500mm/min.Types A and B were observed for the sand (M31) and Type C for the flysch, bentonite and the artificial mixturtes 70/30, 40/60 and 0/100. In particular, sand M31 shows Type A at an normal stress of 427kPa and Type B at the normal stresses of 233kPa and 117kPa. Fast shearing is always accompanied by an increase in the volume of the shear zone of the specimens. This increase in volume increases with increasing rate of displacement and also acceleration.The effect of acceleration which was investigated for the flysch, was negigliple for range 1 of Type C. Contrarily, this effect is very significant in range 2 of Type C. In particular for the tested soils, the flysch and the artificial mixtures it is found that the significant drop in fast residual strength (negative rate effect) is observed when the acceleration exceeds a critical value. The value of this critical acceleration is found approximately equal to 2.22 *10-2m/s2 and 3.22*10-7m/s2 for the flysch and the artificial mixture 70/30 respectively at a normal stress of 233kPa. The results indicate that the value of the critical acceleration decreases with increasing soil plasticity. The significant drop in fast residual strength, observed when the acceleration exceeds the critical value and water is allowed to infiltrate into the shear zone may be attributed to the increase of the volume and the resulting change of the microstructure of the shear zone and in particular to the change of the type and magnitude of its porosity.When water is not allowed to infiltrate into the shear zone of the testes soils, then both in Region 1 and 2 of Type C, only small to negligible drop in fast residual strength is observed, even when acceleration exceeds its critical value.Chapter 7 presents the findings of the thesis regarding the slow drained, immediate fast, fast peak, fast residual and slow peak after fast shearing strengths of tested soils, as well as their practical implications in Geotechnical Engineering. Chapter 8 proposes themes of further research in the subject of the thesis.

Degree

thesis:*
Grantor dc:publisher
Aristotle University Of Thessaloniki (AUTH)
Year dc:date
2020

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Katsios, Efstathios
  • Κάτσιος, Ευστάθιος

Subjects

dc:subject × 21

Rights

Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/48654

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Katsios, Efstathios; Κάτσιος, Ευστάθιος. Η επίδραση της χρονικά μεταβαλλόμενης ταχύτητας διάτμησης στην παραμένουσα αντοχή του εδάφους. Aristotle University Of Thessaloniki (AUTH), 2020. http://hdl.handle.net/10442/hedi/48654