National Technical University of Athens (NTUA)
Διαχωρισμός πολύ λεπτομερών τεμαχιδίων στείρου από μαγνησίτη με συνδυασμό εκλεκτικής συσσωμάτωσης και μαγνητικού διαχωρισμού
Abstract
dc:descriptionThe objective of the current research is to investigate the possibility of separating very fine gangue particles from magnesite of similar size.Magnesite tailing from the area of Mantoudi (Euboea) was used throughout the tests, with ultimate goal the production of marketable product.X-ray diffraction (XRD) analysis showed that the major mineral components of the material to be investigated are: magnesite (MgCO3), serpentine in the form of chrysotile [Mg3Si2O5(OH)4], olivine in the form of forsterite (Mg2SiO4) and ilmenite (FeTiO3), while the minor minerals are talc [Mg3Si4O10(OH)2], dolomite [CaMg(CO3)2], sepiolite [Mg4Si6O15(OH)2•6H2O], calcite (CaCO3) and quartz (SiO2).To meet the target, the processing scheme included the following two stages: a) Selective agglomeration of the gangue minerals, some of which have magnetic properties, and b) separation of the agglomerated minerals from the non-agglomerated ones by sedimentation or magnetic separation.Initially, preliminary tests were performed on pure minerals; then, tests were carried out on artificial mixtures of the minerals, and, finally, on the tailing from magnesite processing.In all tests, natural magnesite ore was used. Even in the preliminary tests, the pure minerals or artificial mixtures originated from magnesite natural ore and had been visually separated by hand sorting.Initially, agglomeration tests were performed with sodium oleate using very fine particles of pure magnesite and gangue, which contained chrysotile, ilmenite and forsterite.In these tests, sodium oleate (C17H33COONa) was used as anionic collector; also, dilute solutions of NaOH and HCl were used as pH regulators. The effect of the following parameters was examined: pH, sodium oleate dose, conditioning time and sedimentation time. For each series of tests, only one parameter changed while the rest remained constant.The results of the tests showed that both magnesite and gangue minerals show the same behavior in relation to sodium oleate in the pH range 7-12. Sodium oleate is absorbed on the surface of both components to, approximately, the same degree. This results in the agglomeration of both components (magnesite and gangue) of the same degree and in the absence of selective separation by agglomeration or in combination with another method.Amine agglomeration tests were then performed. The tests were performed first on pure minerals, then on mineral mixtures in certain proportions and, finally, on tailing from magnesite processing.The reagents used were: dodecylamine (C12H25NH2), which is a primary amine with straight hydrocarbon chain and kerosene, while dilute solutions of NaOH and HCl were used as pH regulators. In the tests performed both on pure magnesite and gangue minerals, the parameters examined were the pH and dodecylamine dose. The conditioning and the sedimentation time were maintained constant in all tests, and equal to 180 sec and 60 sec respectively. For each series of tests, only one parameter changed while the rest remained constant. The results of the tests on pure minerals showed that dodecylamine significantly affects gangue minerals, consisting of forsterite, chrysotile, ilmenite and/or talc, while it has zero or very small effect on pure magnesite, depending on pH. Finally, it has an intermediate effect on gangues consisting of magnesite, dolomite and chrysotile. Based on these results, it seems possible to separate magnesite from gangue consisting of forsterite, chrysotile, ilmenite and/or talc.In regard to dodecylamine dose, it has a significant effect on gangue minerals consisting of forsterite, chrysotile, ilmenite and/or talc while it has zero or very small effect on pure magnesite for dose between 500 and 3,000 g/t. It also has an intermediate effect on gangues consisting of magnesite, dolomite and chrysotile. Based on the above results, it appears that the increased amount of dodecylamine has a positive effect on the separation as the weight difference between agglomerated gangues and magnesite broadens.The combination of dodecylamine and kerosene appears to result in an increase of the settled material weight. Kerosene has a greater effect on the gangues than on magnesite. Microscopic observations of the agglomerates, with and without kerosene, show that the structure of gangue agglomerates is significantly affected by the addition of kerosene, as they are larger and are held much stronger than the agglomerates formed with dodecylamine only. In contrast, there is no significant difference by the addition of kerosene in magnesite suspensions.In reference to artificial mineral mixtures, the results of the tests show that there is tendency of materials (magnesite, gangue) separation in the entire pH range between 7 and 11, with magnesite being concentrated, primarily, in the suspensions and the gangue in the agglomerated material, as shown by the products content.In the pH range between 7 and 9, there is a significant increase in MgCO3 content by 10 to 15 units (maximum at pH =7); however, the recovery of magnesite in the suspension is generally low (less than 30%), with the exception at pH = 7 which corresponds to recovery of about 56%.The results of the tests on tailings from magnesite processing were not in complete agreement with the results on synthetic mixtures. In tests on tailings, an increase in MgCO3 content of the suspension was observed only for pH = 9, but with low magnesite recovery. For pH values 7 and 8, no significant change in MgCO3 content was observed in the suspension or the agglomerated product. On the contrary, at pH = 11, the MgCO3 content of the suspended material was much lower than that of the agglomerated material, which suggests that dodecylamine also affects magnesite, resulting in its agglomeration and precipitation.The general conclusion from the tests on tailings is that the aforementioned components (magnesite, gangue) cannot be separated by selective agglomeration and sedimentation using dodecylamine, either due to the agglomeration of both materials or to entrapment of one material in the agglomerates of the other.Based on the results of the aforementioned tests and taking into account that some of the gangue minerals have magnetic properties, attempts were made to separate magnesite from gangue minerals by a combination of selective agglomeration and magnetic separation. The purpose of the tests was to achieve the inclusion of non-magnetic gangue minerals in the magnetic gangue agglomerates, and their susequnet removal by magnetic separation. Tests were performed on pure gangue minerals as well as on magnesite processing tailing (with and without the presence of dodecylamine).From the tests performed on gangue minerals, it was observed that some of the minerals contain a small amount of magnesite (7-14%). In regard to gangue containing magnesite, no difference in the content of the product was observed, possibly due to entrapment, simultaneous agglomeration of magnesite or incomplete liberation of magnesite from the gangue. In contrast, the gangue with magnesite as main component was almost entirely concentrated in the non-magnetic product.The experiments using tailings show that without collector the magnetic separation results in a small increase of MgCO3 content (about 2-5 units), while the addition of dodecylamine significantly improves the content of the non-magnetic product (by 10-13 units) at the basic pH region. Also, the products are marketable as they have MgCO3 content of the order 84% to 91% for dodecylamine dose ranging from 2 to 5 kg per tonne of ore.The originality of this research work in relation to the previous ones lies on the simultaneous, selective and broad agglomeration of all gangue minerals, some of which have magnetic properties. This allows the subsequent separation of the gangue magnetic agglomerates from the fine (non-magnetic) magnesite by applying magnetic separation. The above procedure can be applied to other similar cases, aiming at the separation of very fine, non-magnetic particles from very fine minerals with magnetic properties
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2020
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Bimpilas, Georgios-Michail
- Μπιμπίλας, Γεώργιος-Μιχαήλ
Subjects
dc:subject × 17- Μαγνησίτης
- Λευκόλιθος
- Μαγνητικός διαχωρισμός
- Δωδεκυλαμίνη
- Εκκλεκτική Συσσωμάτωση
- BENEFICIATION OF -2 MM MAGNESITE TAILINES
- MAGNETIC SEPARATION
- DDA
- Selective agglomeration
- Μηχανική Υλικών
- Επιστήμες Μηχανικού και Τεχνολογία
- Μεταλλουργία και Μεταλλουργική μηχανική
- Μέταλλα και Κράματα
- Materials Engineering
- Engineering and Technology
- Metallurgy and Metallurgical Engineering
- Metals and Alloys
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/50029