Institutes outside Greece
Indium-zinc oxide nanostructure materials based sensors for the detection of volatile organic compounds and carbon monoxide
Abstract
dc:descriptionDetection of poisonous and flammable gases for health and security purposes utilizing semiconductor metal oxides (SMO) based sensors has attracted ample attention owing to their incomparable advantages, such as a piece of flawless evidence in a variation of their sensor resistance when exposed to either reducing or oxidizing gases. Moreover, their rapid response, recovery times, and remarkable sensitivity make them appealing. It is well-known that an anticipated gas sensor ought to possess a combination of enhanced sensitivity, excellent selectivity, rapid response-recovery times, long-term stability, and low working temperature. These factors mostly rely on surface area to volume ratio, higher relative concentration of defects, and the SMO sensing layer crystal structure. Moreover, this work is justified by the demand for gas sensors globally, with the market estimated to reach approximately R38.4 billion by 2020. According to the World Health Organization (WHO) and World Bank, about 5.5 million deaths happen annually costing the world economy R70 trillion a year due to air pollution. In South Africa about 20 000 deaths occur every year, costing the economy nearly R300-million due to air pollution. Recently, the WHO has indicated that most of the cities in SA (such as Pretoria, Johannesburg, etc.) exceed the limit of air quality (AQ) by roughly five times the WHO recommendation, while over 90% of the world's population lives in areas that exceed WHO limits on air pollution. Therefore, this study investigates the room temperature (RT) NO2 gas sensing properties of p-type NiO, Mn3O4, and CuO nanostructures prepared using a hydrothermal method. Besides, the ferromagnetic features of these structures were also investigated. The gas sensor fabricated from Mn3O4nanorods disclosed remarkable sensitivity and responses to 40 ppm NO2 and an unpreceded selectivity to NO2 over the interference gases such as CO, NH3, CH4, benzene, ethanol, acetone, and toluene at RT. The incomparable response and selectivity to 40 ppm NO2 are associated with the immensely gas accessibility persuaded by sufficient porosity, high surface area per unit volume, and point defects of Mn3O4. An observed linear behavior demonstrated by the Mn3O4-based sensor between response and concentration (adj R2= 0.99507), validated that the material is suitable for NO2 detection. Additionally, a detailed study of gas sensing features of ZnO nanostructures prepared at various pH and reaction times was examined at various operating temperatures and target gases. The gas sensor developed from ZnO prepared for 4h at 10.5 pH established a low sensing response (i.e.resistance ratio) when exposed to some reducing gases, CO, CH4, and NH3, volatile organic compounds, ethanol, and acetone, some families of BTEX, such as benzene and toluene and oxidizing gas (NO2), whereas exposed to H2S gas unpreceded and reproducible response that is approximately 3 times higher than the interfering gases at a low operating temperature of 75 °C was observed. The extraordinary response that facilitated the low operating temperature gas sensing of 40 ppm H2S was elucidated by the improved gas accessibility and relative concentration of VO induced by structural transformation, which induced change in oxygen adsorption, while the high H2S gas selectivity was ascribed to the reactivity of H2S and low-temperature decomposition to participate in the reactionwith ZnO nanoplatelets-based sensor.Finally, the acetone vapor gas sensing characteristics of indium-doped ZnO (ZnO: In) nanostructures prepared by the simple hydrothermal assisted methodwere witnessed. The selective detection of acetone vapor gas was observed by altering the surface structure of ZnO crystals through doping of indium on the ZnO lattice. The ZnO cubic structures primarily exposed in the corresponding [100] facets revealed a higher response towards acetone at an operational temperature of 125 °C. An extraordinary selective detection and rapid response-recovery times toward acetone amongst other interference gases (CO, CH4, NH3, H2S, ethanol, benzene, toluene, and NO2) was perceived. The sensor response is associated with the effect of exposed facets and specific surface area. The details for the superior response towards acetone vapor were also conferred, especially from the perception of intrinsic point defects. The fundamental gas sensing mechanisms are debated in detail.The selective NO2, H2S, and acetone detection in this work proposes that these Mn3O4, ZnO, and ZnO: In nanostructures are potential candidates for gassensing application in households, workplaces, etc.
Degree
thesis:*- Grantor dc:publisher
- Institutes outside Greece
- Year dc:date
- 2019
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Kortidis, Ioannis
- Κορτίδης, Ιωάννης
Subjects
dc:subject × 22- Οξείδιο ινδίου
- Οξείδιο ψευδαργύρου ZnO
- Αισθητήρες αερίων
- Οργανικών πτητικών ενώσεων
- Τοξικοί χημικοί ρύποι
- Μονοξείδιο του άνθρακα
- Indium oxide InO2
- Zinc oxide ZnO
- Nanostructures
- Gas sensors
- Volatile organic compounds
- Indoor outdoor air pollution
- Νανοτεχνολογία
- Επιστήμες Μηχανικού και Τεχνολογία
- Νανοεπιστήμη και Νανοτεχνολογία
- Άλλες Επιστήμες Μηχανικού και Τεχνολογίες
- Μηχανική και Τεχνολογίες, άλλοι τομείς
- Nano-Technology
- Engineering and Technology
- Nanoscience and Nanotechnology
- Other Engineering and Technologies
- Engineering and Technologies, miscellaneous
Rights
- Language dc:language
- eng
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/50798