Back to search

National Technical University of Athens (NTUA)

Μελέτη μεθόδων παραλαβής καροτινοειδών από παραπροϊόντα τομάτας

Abstract

dc:description

The objective of the present thesis is to study the recovery methods of carotenoids from tomato processing by-products, in order to be used as naturalantioxidants or as additives for the formulation of functional foods. Fresh tomato industrial waste (from industrial hybrids Red Sea and Oval Red) was air dried and ground to 1.0 mm particle size. Organic solvent extraction has been studied as the most established method for the recovery of carotenoids in food industry and the parameters affecting the extraction yield were determined. The organic solvents used were hexane, acetone,ethanol, ethyl acetate and ethyl lactate. The effect of time (5-40 min) on carotenoid extraction from tomato waste was investigated by conducting experiments during the first extraction step in all the above mentioned solvents, at 25 °C. A mathematic equation describing the prediction rate of carotenoids in each solvent was determined and the equation parameters as well as the respective correlation coefficients were estimated by nonlinear regression analysis. Carotenoid concentration increased with time, approaching a quasi-saturated condition at approximately 30 min of extraction; therefore, the extraction time of 30 min was chosen for adequate recovery of carotenoids at each extraction step. The extraction temperature (25 °C-70 °C) was chosen on the basis of the boiling point of solvents avoiding possible isomerization and/or oxidation of carotenoids. The extraction yield was significantly affected (P < 0.05) by the increase in extraction temperature. The extraction efficiency was affected by the solvent type and its polarity. Ethyl lactate presented remarkably higher yields, compared to the other solvents, which was increased (from 202.73 to 243.00 mg kg-1 dry tomato waste), as extraction temperature increased from 25 °C to 70 °C. The other solvents showed much lower yields in the following order: acetone (51.90 mg kg-1) > ethyl acetate (46.21 mg kg-1) > hexane (34.45 mg kg-1) > ethanol (17.57 mg kg-1), at the maximum selected extraction temperatures. The effect of successive extraction steps on the carotenoid recovery was subsequently examined, in all the selected solvents and temperatures. For all the solvents, the first extraction step turned out to be the controlling one, in terms of carotenoid yield and percentage recovery. The use of medium polar or nonpolar solvents (ethyl acetate and hexane) increased the percentage recovery of carotenoids (70-74 %) in the first extraction step, compared to the respective one (55-68 %) obtained by more polar solvents (acetone and ethanol). During the third extraction step, the carotenoid percentage recovery was less than 10 % in all solvents, except ethanol, and could eventually be omitted. Following the experimental study, the extraction yield of tomato waste carotenoids was assessed in mixtures of nonpolar and polar solvents, namely, hexaneethanol (50:50, v/v), hexane-acetone (50:50, v/v) and hexane-ethyl acetate (50:50, v/v) mixtures. The combination of hexane with ethanol or ethyl acetate improved the total carotenoid yield compared with that obtained by any of the individual solvents. The highest carotenoid yield was obtained when carotenoids were extracted with hexaneethyl acetate (50:50, v/v) mixture. Extraction conditions, such as mixture composition, solvent to waste ratio and particle size were further optimized using a statistically designed experiment. By means of Responsive Surface Methodology and experimentalBox-Behnken design, a regression equation for predicting the carotenoid yield as a function of three extraction variables was derived and a model with predictive ability of 0.97 was obtained. The optimized conditions for maximum total carotenoid yield (37.5 mg kg-1 dry waste) were the following: hexane-ethyl acetate (45:55, v/v) mixture, solvent to waste ratio of 9.1:1 (v/w) and particle size 0.56 mm. A HPLC-DAD was developed for the efficient separation and analysis of the carotenoids and their cis-isomers, originating from a wide range of foods of plant, animal and marine origin. The identified carotenoids in all solvent extracts from dry tomato waste followed the order: lycopene > b-carotene > lutein, in their predominant trans-configuration. Among the identified isomers, 5-cis lycopene and 15-cis-bcarotene were the most abundant in all solvent extracts. The increase of extraction temperature increased the respective αll-trans lycopene concentration in all solvent extracts, whereas the percentage of cis-isomers to total lycopene (αll-trans + cis) was lower than 8 % in all solvent extracts, other than ethanol (20.0 %) and acetone (17.3 %) extracts, at 70 °C and 50 °C, respectively. A steadily high percentage of cis-isomer (≈30.4 %) was observed upon increasing the temperature from 25 °C to 70 °C in ethyl lactate extracts. Conversely, the increase of extraction temperature induced a reduction in total b-carotene and total lutein concentration in all solvents, but did not cause any further isomerization. The next field under investigation was the influence of drying and storage conditions on the recovery and stability of carotenoids, especially lycopene, obtained from fresh tomato processing by-products. The dehydration treatment was performed as following in the four methods: (a) air-drying at room temperature (25 °C -30 °C), (b) air circulation oven at 70 °C, (c) vacuum oven at 70 °C and (d) freeze-drying. The drying method affected significantly lycopene isomerization with a considerable increase of cis-isomers and a simultaneous reduction of all-trans configurations. Fresh tomato waste contained mainly αll-trans lycopene (99.7 %), while the cis-isomers were absent (0.3 %). The storage of fresh tomato processing by-products at -20 °C for 60 days caused a degradation of total lycopene content by 13.5 % compared to the fresh tomato waste, while a small percentage of isomerization was observed (2.4 %) during storage. Further research aimed at the investigation of enhancing carotenoid extractability by enzyme pretreatment of industrial tomato processing by-products, in fresh and dry state, prior to solvent enzymes chosen for treatment were cellulase (Cellulyve AN 3500) and pectinase (Pectinex Ultra AFP). After determination of the improved incubation conditions for both enzymes (cellulase and pectinase concentrations of 70 U/g and 122.5 U/g, respectively, and incubation time 180 min for both enzymes), the effect of enzyme treatment combined with different extraction solvents on total carotenoid yield and lycopene content was furtherinvestigated. The treatment with pectinase increased the extraction of total carotenoids and especially of lycopene, compared to cellulase, when hexane and ethyl lactate were used as solvents. The enzyme treatment of fresh industrial tomato waste prior to extraction with ethyl lactate improved significantly lycopene content, compared with the respective of the conventional extraction (with the same solvent, without enzyme treatment) in the first extraction step. An equivalent effect was not observed with the other extraction solvents. Nevertheless, the higher lycopene recovery (88.0 %) obtained from fresh tomato waste, as compared with the respective one obtained by conventional extraction (with the same solvent in 3 extraction steps), was observed after enzyme treatment with pectinase and hexane-ethyl acetate (50:50,v/v) mixture as extraction solvent. In the context of exploring "environmentally friendly" extraction techniques, the extraction with supercritical carbon dioxide was studied. Extractions were performed at P=250 and 295 bar, T=55 °C and 65 °C, flow CO2=2.0 mL/min, and extraction time=3 h. The oleoresin and carotenoid yields were compared with therespective ones obtained by Soxhlet extraction with hexane: acetone (1:1, v/v) mixture. The maximum recoveries of all-trans lycopene (15.3 %) and all-trans bcarotene (11.5 %), as compared with those of Soxhlet extraction, were achieved at P=295 bar and T=65 °C. It was concluded that the examined conditions were not sufficient for the recovery of significant amount of carotenoids. The application of High Hydrostatic Pressure technology (HHP) for extracting carotenoids from tomato waste constitutes a new field for exploration and development. Factors influencing the effectiveness of the method [solvent type, pressure: 100-800 MPa, extraction time: 1-30 min and solvent: waste ratio (4:1, 6:1, 10:1, v/w)] were examined and compared with the conventional extraction with thesame solvent. The improved conditions of high pressure treatment were determined (P=700 MPa, t=10 min) and were selected as the processing parameters enabling the highest total carotenoid extraction yield. Generally, high pressure assisted extraction was performed in a shorter treatment time (10 min) and a lower solvent: waste ratio, compared to atmospheric pressure extraction with the same solvents, without significantly affecting the extraction yields. The results of the present thesis evidence the existence of interesting alternative perspectives to traditional classical extraction for carotenoid recovery from low cost raw materials. However, further parameters should be explored and evaluated economically in order to make feasible their industrial implementation.

Degree

thesis:*
Grantor dc:publisher
National Technical University of Athens (NTUA)
Year dc:date
2014

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Strati, Eirini
  • Στρατή, Ειρήνη

Subjects

dc:subject × 14

Rights

Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/51197

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Strati, Eirini; Στρατή, Ειρήνη. Μελέτη μεθόδων παραλαβής καροτινοειδών από παραπροϊόντα τομάτας. National Technical University of Athens (NTUA), 2014. http://hdl.handle.net/10442/hedi/51197