Back to search

Aristotle University Of Thessaloniki (AUTH)

Sampling, measurement and characterization of exhaust gas nanoparticles smaller than 30 nm

Abstract

dc:description

The adverse effects of air pollution on human health are well recognized, with 0.4 and 7 million annual premature deaths caused by air pollution in the European Union (EU) and the world, respectively (Ortiz et al., 2019)(WHO, 2012). Particle emissions from vehicles comprise a large share of air quality deterioration in European cities. Road transport contributes 11% of total emissions of particulate matter (PM) with aerodynamic size up to 2.5 μm (PM2.5) and 28% of black carbon (BC) (Ortiz et al., 2019). In particular, ultrafine particles below 100 nm in size have received separate attention, owed to their high mobility and penetration within the body (Miller et al., 2017). Road transport contributes almost up to 90% of the total emissions of such ultrafine particles (Kumar et al., 2010; Pey et al., 2009) that may equally originate from both exhaust and non-exhaust emissions (brake or tyre wear emissions) (Grigoratos & Giorgio, 2014). The need to improve air quality, in particular in terms of airborne particle concentrations, imposes ambitious goals in vehicular combustion efficiency and exhaust emissions reduction.Emission regulations are the driving force for the constant development in combustion efficiency and emission control technologies of vehicles. The SPN size threshold of 23nm is the current EU cut-off size for positive and compression ignition direct injection (DI) engines under the Euro 6 emission standard. Although total particulate mass emissions from vehicles have decreased over the years, a large fraction of them is located in the region below 10 nm. For GDI vehicles, the GMD has dropped from 70nm (Euro 2) to less than 30nm (Euro 6) (Giechaskiel, Joshi, et al., 2019). For Euro 6 CNG vehicles, the GMD appears below 25nm (Giechaskiel, Lähde, et al., 2019). As regards DPF equipped vehicles, although such vehicles are generally considered to be low PN emitters, our understanding of the contribution of diesel particle filter (DPF) regenerations to actual PN emissions on the road is in general limited. Studies conducted so far report up to 3 orders of magnitude higher SPN23, during such events, compared to normal driving (Amanatidis et al., 2014; Dwyer et al., 2010; Krajinska et al., 2020; Mamakos & Martini, 2011; Papadopoulos et al., 2020). However, there is little information on what happens to emissions of smaller particles during DPF regeneration.In this context, the current work aims to investigate the volatile and non-volatile emissions of the latest technology passenger cars, extending the particle size range down to 2.5nm. To achieve this, a novel raw exhaust sampling system with enhanced separation of solid particles and limited nanoparticle losses was utilized. The results aim to provide an assessment of the impacts of alternative fuels and engine combustion technologies on vehicle emissions and inform the next generation of emission standards and control.Τhe present dissertation was developed as follows:Chapter 1 sets out the problems of particulate emissions from internal combustion engines, presents the current legal framework for the identification of such particles as well as recent reports on the emissions of volatile and non-volatile particles from modern engines. The objectives of this dissertation are presented at the end of this chapter.Chapter 2 sets out the methodology for determining particulate emissions under laboratory conditions and actual driving conditions.From Chapter 3 to Chapter 5 are set the answers in the main research questions presented in Chapter 1. Specifically, the questions that are analyzed and answered are the following:1.How are particulate emissions affected by driving conditions and specific engine operating conditions (DPF active regeneration)? A detailed gaseous and PN emissions analysis of a Euro 6d-temp is presented. 2.Is legislative particle identification sufficient for the identification of nanoparticles in alternative fueled engines? The PN results from lab measurements in three CNG / petrol bi-fuel cars are analyzed. 3.Is it important to identify volatile particles alongside non-volatile particles? Proposal for the improvement of the particle identification methodology through the adoption of non-volatile particle measurement technology. Relative experimental data from a CNG / petrol bi-fuel passenger vehicle are analyzed. Chapter 3 investigates gaseous and particulate emissions of a diesel passenger car (Euro 6d-temp), under specific operation events, including diesel particulate filter (DPF) active regeneration. The contribution of DPF active regeneration to sub-23nm volatile and solid particle emissions was investigated in a dedicated measurement campaign. A novel exhaust gas sampling and dilution system was employed for the determination of solid particle number (SPN) emissions down to 23nm, 10 nm, and 2.5 nm. Total particle number (TPN) emissions, including semi-volatiles, down to 10 nm and down to 5.6 nm were also measured. A DPF active regeneration was triggered during on road testing. DPF regeneration increased NOx and SPN down to 23 nm (SPN23) by 1.7 times and 3 orders of magnitude, respectively, compared to non-regenerating conditions. A second DPF regeneration was triggered during steady-state conditions in the laboratory. Once again, SPN23 emissions were at least 3 orders of magnitude higher compared to normal operation. Under regeneration conditions, SPN down to 2.5nm (SPN2.5) was 2.3 times higher than SPN23, which suggests that a significant number of particles reside below the regulated limit of 23 nm during DPF regeneration. Moreover, TPN emissions were at least 7 times higher than SPN ones. Both these observations suggest that a significant number of particles during DPF regeneration evades current SPN23 regulation. Based on the DPF active regeneration findings in RDE and lab conditions, the current study introduces an enhanced particulate emission factor that includes the impact of active DPF regenerations. Chapter 4 investigates the non-volatile particle number emissions of three bi-fuel passenger cars (Euro 6b, 6d-temp), which operate on compressed natural gas (CNG), as a primary fuel, and gasoline as a secondary one. The CNG fuel was injected into the engine using port fuel injection (PFI) while the gasoline fuel was either by PFI or by direct injection (GDI). A novel exhaust gas sampling and dilution system was employed for the determination of solid particle number (SPN) emissions at 10nm (SPN10) and 2.5nm (SPN2.5). The vehicles were tested in the laboratory over different test cycles where the CNG solid particle number emissions greater than 23 nm (SPN23) were an order of magnitude lower than GDI and PFI gasoline emissions. However, when the size threshold was lowered to 10nm or 2.5nm, emissions were similar for both fuels. Particularly, SPN2.5 emissions of the Euro 6b vehicle exceeded the Euro 6 emission standard for both fuels while the SPN23 emissions were between 40 and 2.8 times lower than the limit for CNG and gasoline, respectively. Particle size distributions show a significant number of particles residing below the regulated limit of 23nm, even lower than 10nm. The results have significant implications in setting a particle number limit for alternative fuel vehicles while indicating that the current size threshold (23nm) is insufficient for particle emission testing. The main objective of the Chapter 5 is the identification of sub-23nm volatile and non-volatile particle emissions from a latest technology PFI vehicle, which operates on compressed natural gas (CNG, Euro 6d-temp), as a primary fuel, and gasoline as a secondary one. A state of the art exhaust gas sampling and dilution system along with an FTIR spectrometer were utilized for tailpipe emission testing under chassis dyno laboratory conditions. Other fuel alternatives, such as Alkylate (which is considered a pure renewable fuel) and fuel blends with octane booster MMT were also investigated. The low content in aromatics Alkylate had the lowest TPN emission performance that was below the Euro 6 limit. The parameter of dilution temperature was further analyzed since it poses a significant sensitivity to the total particle testing, especially in fuels with a high H/C ratio such as the CNG due to water production in the exhaust. Evidence suggests a dilution temperature of >75 oC is required to avoid water related volatile particles. The technical feasibility of TPN particle filtration via particulate filters (PF) was also tested in this work. Results indicate effective filtration of non-volatile and volatile particles, especially in the sub-23nm size range. Gasoline tests with PF, suggest TPN10 emissions in the order of 5x1011 p/km, below the Euro 6 regulation limit. Current results suggest that the implementation of TPN10, seems to be feasible in future regulation. Current technology PFs and ultra clean fuels such as Alkylate gasoline are suitable for TPN filtration and low emission performance, respectively. Chapter 6 presents the conclusions from the analysis of the initial research questions presented in Chapter 3 to Chapter 5, which can be summarized in the following:Chapter 3•A significant number of particles during regeneration evade current SPN23 regulation•Up to an order of magnitude higher TPN10 than SPN10 during active regeneration•Passive regeneration contributes up to 100 times higher SPN23 than normal operation•Enhanced emission factor that includes the effect of DPF active regeneration suggests up to 3.9 times higher SPN23 based on regeneration findingsChapter 4•CNG solid particle number emissions greater than 23 nm (SPN23) were an order of magnitude lower than GDI and PFI gasoline emissions•Emissions were similar for both CNG and gasoline fuels in 10 nm or 2.5 nm size threshold•SPN2.5 emissions of the Euro 6b vehicle exceeded the Euro 6 emission standard for both CNG and gasoline fuels.•SPN23 emissions were between 40 and 2.8 times lower than the limit for CNG and gasoline, respectively•Particle size distributions show a significant number of particles reside below the regulated limit of 23 nm, even lower than 10 nmChapter 5•Focus on particle number emission performance on a latest technology PFI on various alternative fuels•At least an order of magnitude higher TPN emissions than SPN ones •Experimental work suggests ≥ 75 oC as minimal sampling temperature, during TPN emission testing to avoid water condensates•High TPN emission events under fuel cut-off events, related to lube oil•Under 150 oC dilution temperature conditions, the SPN/TPN parallel testing on CNG operation, suggests that 2.7% of the TPN emissions were solid particles•PF implementation reduces TPN emissions to within Euro 6 limitsThe dissertation ends up with Chapter 7, where the proposed future extensions of the present research are listed.The novelty of this doctoral dissertation can be summarized in the following points:•PN emissions study of latest technology conventional engines (DI / PFI) under Euro 6b or later emission standards.•Experimental results from bi-fuel CNG / petrol engines with Euro 6b emission standards and later.•Experimental analysis of specific engine events such as active and passive diesel particle filter (DPF) regeneration under laboratory and real driving conditions.•Study of the effect of driving dynamics on PN emissions in real driving conditions.•Study of the effect of alternative fuels such as paraffin gasoline (Alkylate) and octane booster additives (MMT) on volatile and non-volatile emissions.

Degree

thesis:*
Grantor dc:publisher
Aristotle University Of Thessaloniki (AUTH)
Year dc:date
2022

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Toumasatos, Zisimos
  • Τουμασάτος, Ζήσιμος

Subjects

dc:subject × 16

Rights

Language dc:language
eng

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/51998

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Toumasatos, Zisimos; Τουμασάτος, Ζήσιμος. Sampling, measurement and characterization of exhaust gas nanoparticles smaller than 30 nm. Aristotle University Of Thessaloniki (AUTH), 2022. http://hdl.handle.net/10442/hedi/51998