Back to search

University of Ioannina

Ανάπτυξη φωτοκαταλυτών γραφιτικού νιτριδίου του άνθρακα (g-C3N4) με περιβαλλοντικές εφαρμογές

Abstract

dc:description

In recent years, environmental pollution and the energy crisis have been among the most serious problems facing humanity. Both organic pollutants, such as phenolic compounds, pharmaceutical compounds, pesticides, plasticisers, etc., and toxic metal ions (e.g. Cr(VI)) have been detected in recent years in increasing concentrations in the aquatic environment, causing concern about the effects on human and animal health. The increasing detection of these pollutants is due to the rapid growth of industry, the multitude of products used, and modern human lifestyle. Modern wastewater treatment methods must have the capacity to degrade organic pollutants and ideally to remove inorganic pollutants at the same time. Research to date has shown that conventional treatment methods do not have the required capabilities. This fact led to the development of new and more effective methods such as Advanced Oxidation Processes (AOPs), whose effectiveness is due to the creation of strong oxidative radicals. Heterogeneous photocatalysis, one of the most important POPs, has applications for both oxidation and reduction of pollutants and can therefore also be used for the combined removal of organic molecules and toxic metals. Among the semiconductive materials that have been systematically studied in recent years for photocatalytic oxidation applications in aqueous systems, graphitic carbon nitride (g-C3N4) has been intensively studied due to its promising physicochemical characteristics such as its absorption in visible light, its stability, its ability to heterojunction with other semiconductors, its suitable potentials for oxidation and reduction applications and its synthesis from cheap raw materials. In addition, molybdenum sulfide, an important member of the transition metal dichalcogenide family, is attracting considerable scientific interest due to its electronic, chemical and optical properties and its use as a photocatalyst or co-catalyst in heterogeneous photocatalysis. In this Ph. D. thesis, the synthesis of graphitic carbon nitride (g-C3N4) and molybdenum disulfide (MoS2), as well as MoS2/g-C3N4 composites in different ratios was carried out. The synthesis of g-C3N4 was achieved by calcination of urea at 500 °C for 4 hours. The synthesis of MoS2 was performed by hydrothermal method at 200o C for 12 h and the precursors used were thiourea and ammonium heptamolybdenum hydrate. The synthesis of the heterostructures was carried out by the mixing-precipitation method in the presence of ultrasound and then calcination was carried out at 200o C for 2 hours. The selected ratios were x% weight by weight (wt%) MoS2/ g-C3N4, where x = 0.5, 1, 3, 10. The code names of the prepared materials are CN, MS, 0.5MSCN, 1MSCN, 3MSCN and 10MSCN.The physicochemical characterization of the synthesized materials was performed using the following techniques: X-ray diffraction (XRD), Infrared Spectroscopy (ATR FT-IR), Diffuse Reflectance Spectroscopy visible-ultraviolet (UV–Vis DRS), Scanning Electron Microscopy (SEM), Liquid Nitrogen Porosimetry (Ν2 porosimetry) and Dynamic Light Scattering (DLS).The MS peaks detected in the X-ray diffraction patterns reveal its hexagonal structure. The intensity of the CN peaks decreases with the increase of MS percentage in composite materials. The ATR-FT-IR spectra showed the characteristic peaks of both CN and MS. The energy gap of the materials was calculated via the Kübelka-Munk equation. The energy gap of the materials ranges from 1.31 eV to 2.66 eV. Eg values followed the order: 1MSCN > 3MSCN = 10MSCN > CN > 0.5MSCN > MS. The CN, 0.5MSCN, 1MSCN, 3MSCN and 10MSCN materials exhibited adsorption isotherms belonging to class IV(a) with an H3 hysteresis loop. MS exhibited a non-porous structure. In SEM images, MS shows aggregates of spherical particles. In the composites, and especially in 10MSCN, the aggregates are shown on the stacking sheets structure of CN, indicating the successful synthesis of the heterostructures. The photocatalytic activity of the materials was first tested on single systems of the selected pollutants phenol and Cr(VI). Experiments were carried out in a Suntest solar radiation simulator, with an irradiance of 500 W m-2, catalyst concentration of 100 mgL-1 and a pollutant concentration of 10 mgL-1. The photocatalytic degradation of the pollutants in all cases followed pseudo-first order kinetics. In the single phenol system, 91% oxidation was achieved after 120 min of irradiation in the presence of CN. The photocatalytic activity of the materials followed the order CN > 1MSCN > 0.5MSCN = 10MSCN > 3MSCN > MS. In the single Cr(VI) reduction system, MS showed the strongest results, with a photocatalytic reduction rate of 30% at the end of the photocatalytic process. The photocatalytic activity of the materials is given by the sequence. Simultaneous removal of pollutants was studied in photocatalytic experiments of phenol:Cr(VI) binary systems in two different ratios, 1:5 and 1:10. In the binary system with a 1:5 pollutant ratio, CN showed the highest efficiency in the removal of both pollutants. An increase in Cr(VI) leads to an increase in the oxidation rate of phenol, improving charge carrier separation and synergistic activity. Increasing Cr(VI) leads to an increase in the oxidation rate of phenol, confirming the synergistic effect. Phenol oxidation experiments were carried out using the photocatalyst 1MSCN in the presence of scavengers (IPA, SOD, TEOA) and the proposed photocatalytic mechanism, according to the experimental results, is the Type-II mechanism. The stability of the heterostructures was evaluated in three consecutive photocatalytic cycles of phenol oxidation in the presence of 1MSCN catalyst. An overall decrease in photocatalytic activity of 7.8% was observed at the end of the third cycle indicating the stability of the photocatalysts. Subsequently, the effectiveness of heterogeneous photocatalysis in contaminant degradation was tested in the presence of TiO2 and CN photocatalysts in the removal of pharmaceutical compounds detected in secondary treated hospital waste. The experiments were carried out in a pilot-scale CPC (Compound Parabolic Concentrator) photocatalytic reactor installed at the University Hospital WWTP of Ioannina (Northwestern Greece) in the presence of natural solar radiation. Photocatalytic removal of the pharmaceutical compounds followed pseudo-first-order kinetics in all cases. Eleven pharmaceutical compounds were detected in the secondary effluents. As the inherent concentrations of the pharmaceutical compounds were investigated, not all pharmaceutical compounds were detected in all experiments. The optimum catalyst concentration in the photocatalytic system for most pharmaceutical compounds was found to be 200 mgL-1 in the case of TiO2, while for CN it ranges between 200 and 300 mgL-1. The biodegradability at the end of the photocatalytic treatment increased, indicating that part of the compounds was transformed into more biodegradable compounds. In toxicity tests carried out using the Vibrio Fischeri bioluminescence test, the results showed that photocatalytic treatment leads to detoxification of the waste. The catalyst reuse experiments showed that the activity of the catalyst decreases significantly at the end of the photocatalytic cycles. The photocatalytic activity of CN and 1MSCN materials was tested in photocatalytic experiments of pharmaceutical compound degradation in a laboratory-scale pilot reactor (L-PP) and in a Suntest solar simulator. Experiments were performed to study the inherent concentrations of the pharmaceutical compounds and experiments in which inoculation of the secondary treated waste with a standard mixture of pharmaceutical compounds was carried out. In all cases, the photocatalytic removal of the pharmaceutical compounds followed pseudo-first order kinetics. In the presence of the 1MSCN heterostructure, the removal of the studied pharmaceutical compounds was achieved faster. In the experiment performed on L-PP in the presence of 1MSCN, the formation of transformation products was also monitored by a liquid-solid extraction technique and determination by high-resolution liquid chromatography-high resolution mass spectrometry (LC-LTQ-Orbitrap-MS) and six transformation products (TPs) were detected, which were completely removed at the end of the photocatalytic process. According to the results, the coupling of g-C3N4 with MoS2 enhances its photocatalytic performance. The heterostructures proved to be effective both in the simultaneous oxidation of phenol and reduction of Cr(VI), as well as in the degradation of the studied pharmaceutical compounds. g-C3N4 catalysts presented comparable efficiency to reference catalyst TiO2 P-25 for the degradation of pharmaceutical compound residues in secondary treated hospital wastewaters. Heterogeneous photocatalysis is a powerful alternative anti-pollution treatment method over the conventional methods for the removal of emerging pollutants from wastewater systems.

Degree

thesis:*
Grantor dc:publisher
University of Ioannina
Year dc:date
2024

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Rapti, Ilaeira
  • Ράπτη, Ιλάειρα

Subjects

dc:subject × 29

Rights

Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/56318

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Rapti, Ilaeira; Ράπτη, Ιλάειρα. Ανάπτυξη φωτοκαταλυτών γραφιτικού νιτριδίου του άνθρακα (g-C3N4) με περιβαλλοντικές εφαρμογές. University of Ioannina, 2024. http://hdl.handle.net/10442/hedi/56318