Hellenic Open University
Ανάπτυξη ενισχυμένων καταλυτών νικελίου στηριγμένων στο ορυκτό παλυγορσκίτης για παραγωγή ανανεώσιμου ντίζελ μέσω εκλεκτικής αποξυγόνωσης υπολειμμάτων φυτικών ελαίων και λιπών
Abstract
dc:descriptionThis thesis consists of five chapters. In the first chapter, a literature review of the field is conducted, and the needs and requirements for modern catalytic systems in the subject of the thesis are presented. Additionally, the objectives of this thesis are outlined. In the second chapter, the materials/reactants used are presented, along with a detailed description of the experimental procedures followed. The experimental process of processing the mineral palygorskite, the treatment of raw materials, and the synthesis and activation methods of the catalysts are described in detail. Furthermore, the physicochemical characterization techniques used for the raw materials – such as waste cooking oils (WCO), chicken fat (FAT), free fatty acids (FAD) and spent coffee ground oil (SCGO) – are presented. These techniques include: 1) determination of moisture content, 2) determination of iodine value, 3) determination of acidity, 4) determination of viscosity, and 5) determination of saponification value. Their composition was analyzed using gas chromatography and infrared spectroscopy in combination with attenuated total reflectance, while mass loss was studied using thermogravimetric analysis (TGA). The techniques used for the physicochemical characterization of the catalysts (adsorption–desorption of nitrogen at liquid nitrogen temperature, X-ray diffraction (XRD), transmission electron microscopy (TEM), temperature-programmed reduction with hydrogen (H2-TPR), and temperature-programmed desorption of ammonia (NH3-TPD)) are also described. The catalytic behavior of the catalysts was evaluated in a semi-batch reactor, and the analysis of the liquid product composition was carried out using gas chromatography, standard substances, and mass spectrometry. The used catalysts were studied for their texture, crystal size of the active phase, and metallic surface (chemisorption of carbon monoxide), while the coke deposition percentage was determined through total carbon (TC) analysis. In the third chapter, two supported catalysts on mineral palygorskite are compared in terms of their activity: a monometallic nickel catalyst with a loading of 30% w/w (Ni/Pal) and a bimetallic catalyst with a molybdenum promoter (MoNi/Pal), atomic ratio (Ni/Ni+Mo) = 0.95 and a total loading of 30% w/w (27.5% Ni, 2.5% Mo). The primary aim of this study is to investigate the necessity of using a promoter in the catalytic system. The two reduced catalysts were evaluated in the conversion of waste cooking oils into renewable diesel at 310°C, 40 bar H2 with a flow rate of 100 mL/min, 100 mL WCO / 1 g catalyst, for nine hours. From the analysis of the composition of the liquid product at the ninth hour of the reaction, it was found that the addition of the promoter led to a doubling of the hydrocarbon yield from 22% w/w to 45% w/w. This increase was a result of the enhanced nickel active surface area of the catalyst and the promoting action of the molybdenum oxide in the deoxygenation reaction. After confirming the necessity of using a promoter, the study focused on determining the optimal reaction conditions regarding temperature and catalyst amount. The temperatures tested were 310, 330, 350, 370, and 390°C, keeping the other parameters constant. Increase of the temperature led to a higher hydrocarbon yield in the final product and a reduction in intermediate products, such as esters and acids. The optimal temperature for hydrocarbon yield was found to be 370°C (~80% hydrocarbons), and the effect of solvent use was also studied, showing that diluting the oil with solvent did not favor esterification of intermediate products and increased the renewable diesel percentage. Regarding catalyst amount, doubling the catalyst mass increased the available active sites in the given volume of waste cooking oils, resulting in a 14% w/w increase in hydrocarbons in the liquid product. Finally, the effect of the nature of the promoter was also studied. Two additional bimetallic catalysts, WNi/Pal and FeNi/Pal, were evaluated for the conversion of WCO into renewable diesel, under the optimal conditions for MoNi/Pal. The WNi/Pal catalyst showed similar activity to that of the MoNi/Pal, slightly reduced (~89% vs. 94% w/w), possibly due to the formation of a complex between tungsten and calcium present in waste cooking oils. The FeNi/Pal catalyst produced 82% w/w hydrocarbons, but 5% of these contained fewer than 15 carbon atoms.In the fourth chapter, after identifying the optimal catalyst and reaction conditions for the conversion of cooking oils to renewable diesel, the MoNi/Pal was studied for the conversion of three other residual raw materials into hydrocarbons: chicken fat (FAT), free fatty acids (FAD) and spent coffee ground oil (SCGO). The reaction conditions were as follows: 2 g reduced catalyst, 100 mL oil, 40 bar H2, 100 mL/min flow rate, nine hours reaction duration. The hydrocarbon yield for WCO and FAT was 94.1% w/w, for FAD 76.5% w/w, and for SCGO 72.8% w/w. The used catalysts were characterized to study their physicochemical properties. To maximize hydrocarbon production for all raw materials, different reaction temperatures were tested for FAD and SCGO. For FAD, temperatures of 390 and 410°C were tested, while for SCGO, 390°C. The optimal reaction temperature for FAD was 390°C, with a hydrocarbon yield of 83.5%, while for SCGO, the optimal temperature was 370°C, as further temperature increase did not increase hydrocarbons but increased the proportion of lighter hydrocarbons (2.5% w/w) compared to those in the diesel range. For each raw material, catalyst reusability was tested for a second reaction cycle. In all cases, a reduction in hydrocarbon yield was observed. The used catalysts were characterized after the second cycle to investigate the reasons for the reduced activity, with coke deposition being the main suspect. Finally, to assess whether catalyst deactivation is permanent or reversible, the catalysts were regenerated by calcination at the activation temperature for 2 hours and then reactivated with hydrogen. The regenerated catalysts were tested under the optimal conditions for each raw material for 9 hours. In the cases of waste cooking oils and fat, the catalyst activity was fully restored due to coke combustion, but for free fatty acids and coffee oil, the activity of the catalysts could not be fully restored, possibly due to the poisoning of the active sites by nitrogen-containing compounds. The fifth chapter provides a summary of the conclusions of this thesis.
Degree
thesis:*- Grantor dc:publisher
- Hellenic Open University
- Year dc:date
- 2025
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Fani, Konstantina
- Φάνη, Κωνσταντίνα
Subjects
dc:subject × 28- Κατάλυση
- Εκλεκτική αποξυγόνωση
- Ενισχυμένοι νικελικοί καταλύτες
- Ορυκτό
- Παλυγορσκίτης
- Ανανεώσιμο ντίζελ
- Υπολειμματικές πρώτες ύλες
- Φυτικά έλαια
- Ζωικά λίπη
- Catalysis
- Selective deoxygenation
- Promoted nickel catalysts
- Mineral
- Palygorskite
- Renewable diesel
- Residual raw materials
- Vegetable oils
- Animal Fats
- Χημεία
- Φυσικές Επιστήμες
- Εφαρμοσμένη χημεία
- Γεωεπιστήμες και Επιστήμες Περιβάλλοντος
- Περιβαλλοντική χημεία
- Chemical Sciences
- Natural Sciences
- Applied Chemistry
- Earth and Related Environmental Sciences
- Environmental Chemistry
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/58532