Back to search

University of Patras

Mass concentration, composition and sources of atmospheric nanoparticles

Abstract

dc:description

Ultrafine particles (UFPs or PM0.1), are atmospheric particles with diameters smaller than 100 nm. Although these particles dominate atmospheric particle number concentration, they contribute relatively little to particulate matter (PM), rendering their mass and composition measurement challenging. They have physicochemical properties that distinguish them from larger particles. Their small size and large surface area per unit mass facilitate deep penetration into the respiratory system and enable translocation to other organs through the bloodstream, while their large surface area and high surface reactivity enable them to adsorb, for a given mass of PM, greater quantities of hazardous metals. As a result, ultrafine particles are receiving increasing attention as a potentially important component of ambient particulate matter associated with adverse health effects. Nevertheless, the understanding of their atmospheric behavior, chemical composition, and sources remains limited, partly because their typically low mass concentrations make accurate time-resolved measurements particularly challenging. In the first part of this thesis, the relationship between PM0.1 and particle number concentration above different lower size cut-offs was investigated using particle size distribution measurements from several European locations, together with predictions from the three-dimensional chemical transport model PMCAMx-UF. The analysis showed that PM0.1 and the concentration of particles larger than 50 nm (N50) were strongly correlated. Hourly observations from six European urban locations showed that PM0.1 had strong spatial and temporal correlation with N50 (R2 > 90%). The line passing through zero had an average slope of 0.16 0.01 x 10-9 μg, for an assumed unit particle density, indicating that PM0.1 can be measured indirectly but quite accurately and continuously by measuring N50.Based on the above finding, the second part of this thesis focused on the development of a novel approach for the continuous PM0.1 mass measurements using a condensation particle counter (CPC). A water-based CPC was modified to measure N50 (CPC50), and its performance was evaluated by comparing its ambient measurements with measurements from a Scanning Mobility Particle Sizer (SMPS) in Rio, Greece. The PM0.1 concentration was estimated from the CPC50’s N50 measurements and was in good agreement with PM0.1 measured by the SMPS, with a fractional bias of less than 5% and a fractional error of 21% for hourly measurements. These results demonstrated that accurate N50 measurements can be used to estimate PM0.1 continuously and that a CPC-based approach has the potential to provide a substantially simpler and cheaper alternative to an SMPS. Such an approach could facilitate the deployment of PM0.1 measurements over larger spatial scales and provide high-temporal-resolution mass concentration datasets that are currently scarce. Measuring the PM0.1 mass concentration alone, however, does not provide information about its sources or chemical composition. The next part of the thesis therefore focused on the development of a system for continuous chemical characterization and source apportionment of ultrafine PM. An Aerodynamic Aerosol Classifier (AAC) was modified to separate PM0.1 from larger particles and was combined with a high-resolution time-of-flight aerosol mass spectrometer (HR-ToF-AMS), a single-particle soot photometer (SP2-XR), and an Xact625i elemental analyzer. This approach enabled the high-temporal-resolution measurements of organic aerosol (OA), sulfate, nitrate, ammonium, chloride, black carbon (BC), and elemental composition, as well as the source-apportionment analysis of the ultrafine OA. The method was first evaluated during a summertime campaign in Rio, Greece. PM0.1 averaged 0.7 μg m-3 and OA was its most abundant component, contributing approximately 45% of the total mass. Sulfate, calcium, ammonium, BC, and the remaining detected elements contributed approximately 14%, 18%, 7%, 4%, and 7%, respectively, while nitrate and chloride contributed less than 4% each. Source apportionment showed that approximately 80-90% of the ultrafine OA was oxygenated, while primary OA accounted for approximately 10–15%. These measurements demonstrated the feasibility of obtaining detailed chemical and source-related information for PM0.1 continuously, rather than relying on the daily or longer sampling periods required by conventional filter-based approaches. The developed measurement system was subsequently deployed for one-month at a Mediterranean background site on the island of Poros, Greece, during late summer, to investigate ultrafine PM under conditions of strong atmospheric processing, secondary formation, and long-range transport. PM0.1 averaged 0.5 μg m-3 and consisted predominantly of OA and sulfate (40% and 30%, respectively), followed by ammonium and nitrate at approximately 10% each. Frequent new particle formation events were observed near the site, associated with high sulfur dioxide concentrations in the area, which led to sharp increases in PM0.1, sulfate, and particle number around midday. Elemental measurements detected relatively high concentrations of calcium and iron in the ultrafine fraction, potentially associated with the nearby shipping emissions. Particularly notable were periods influenced by volcanic emissions from Mount Etna, approximately 750 km from the measurement site. During these events, sulfur dioxide concentrations increased by approximately a factor of ten and were accompanied by elevated concentrations of zinc, lead, and arsenic in PM0.1, demonstrating the persistence of these heavy metals in the ultrafine fraction even after long-range transport over hundreds of kilometers and substantial atmospheric aging. PM0.1 and PM1 showed only a weak overall correlation (R2 = 0.25), despite both being dominated by OA and sulfate, emphasizing that fine and ultrafine particles can respond differently to regional and atmospheric processes. Finally, the developed chemical characterization system was deployed for a month-long wintertime campaign at an urban background site in central Athens, Greece, to investigate the composition and sources of PM0.1. The average PM0.1 concentration was 1.1 μg m-3, with OA accounting for most of the mass (75%), followed by BC (11%). Total PM0.1 and OA exhibited their highest concentrations during the nighttime, whereas ultrafine BC showed a pronounced morning maximum associated with traffic emissions. Source apportionment analysis identified four PM0.1 OA factors: hydrocarbon-like OA (HOA), cooking OA (COA), biomass-burning OA (BBOA), and oxygenated OA (OOA), contributing 19%, 19%, 13%, and 49% of the ultrafine OA, respectively. Thus, primary OA accounted for approximately half of the PM0.1 OA, with cooking and biomass burning emissions making a particularly important contribution to the ultrafine fraction despite their commonly assumed association with larger accumulation-mode particles. Although PM0.1 and PM1 mass were strongly correlated (R2 = 0.78), aspects of their detailed composition and temporal behavior diverged. OA represented a larger fraction of PM0.1 than of PM₁ (75% compared with 55%), and primary OA factors generally exhibited sharper and earlier peaks in the ultrafine fraction, suggesting their initial emission into smaller particles followed by growth toward larger sizes. In contrast, cooking OA showed little temporal shift between the two size fractions, suggesting a particularly direct contribution to ultrafine PM. Secondary inorganic species also exhibited pronounced differences in their size-dependent behavior, demonstrating that a strong correlation between total PM0.1 and PM1 mass does not necessarily mean identical chemical composition or source dynamics.

Degree

thesis:*
Grantor dc:publisher
University of Patras
Year dc:date
2026

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Argyropoulou, Georgia
  • Αργυροπούλου, Γεωργία

Subjects

dc:subject × 12

Rights

Language dc:language
eng

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/62778

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Argyropoulou, Georgia; Αργυροπούλου, Γεωργία. Mass concentration, composition and sources of atmospheric nanoparticles. University of Patras, 2026. http://hdl.handle.net/10442/hedi/62778