Back to search

Georgia Southern University

An Investigation of the Effects of N-Butanol on Friction and Wear Patterns When Mixed with Ultra Low Sulfur Diesel

Abstract

dc:description.abstract

Diesel fuel dilution is one of the many ways that new biofuels are tested for practical usability. The concern of this experimental work comes from the unique change in viscosity caused by mixing N-Butanol with ultra-low sulfur diesel (ULSD) fuel. The viscosity of the diesel decreases when mixed with the N-Butanol, this change in viscosity could cause increased wear rates and changes in the frictional force in the internal combustion engines in which they are used. The change in viscosity is much the same as when the diesel is mixed with other biodiesel alcohols but at a greater rate; in fact, the viscosity of the mixture is less than the viscosity of the N-Butanol alone but has a flatter slope in the viscosity vs temperature graph. Throughout the viscosity test, the samples are heated causing them to undergo a change in viscosity. The ULSD and ULSD-mixture test samples tend to eventually have a higher viscosity than N-Butanol over the life of the test despite starting at a lower viscosity at the beginning of the test. Research is presented here on the viscosity and tribometer-tested wear and lubricity of N-Butanol and of its mixtures in ultra-low sulfur diesel. The testing of N-Butanol as a lubricity additive follows the procedure outlined by Mozdzen (Mozdzen 1998). This includes tests of the degradation of fuel quality, change in lubricity (Wear and Friction), and crankcase lubricant interaction. The method of testing used a pin on disk tribometer to create wear tracts on test samples. These wear tracts were measured by weighing the samples before and after to determine the mass lost during the test. The friction force was directly measured by the tribometer’s built in force gauge. The tribometer is also outfitted with a force gauge used to measure the frictional force between the pin and disk. The different fuel mixtures were applied to the test sample to study their effects on the wear and friction. These tests found a maximum reduction of wear at 43% compared to pure USD when using a fuel blend of 25% N-Butanol and 75% ULSD. The 25% N-Butanol fuel blend also resulted in lower occurrences of Stick-and-Slip phenomena. Lastly the 25% N-Butanol fuel blend was tested for compatibility with the crankcase lubricant. The test resulted in the fuel blend being compatible with engine oil because of the absence of sediment in the test specimen. When the results are compared against the testing methods outlined by Mozdzen (Mozdzen 1998), N-Butanol passes the requirements to be a lubricity additive for ULSD.

Degree

thesis:*
Name thesis:degree_name
Master of Science, Mechanical Engineering
Level thesis:degree_level
Thesis (open access)
Discipline thesis:degree_discipline
Department of Mechanical Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Morrison, John L, Jr.
Contributors dc:contributor
  • Valentin Soloiu
  • Aniruddha Mitra

Subjects

dc:subject × 5

Rights

Identifiers

dc:identifier.*
Repository record dc:identifier
https://digitalcommons.georgiasouthern.edu/etd/2094

Chain of custody

source
Harvested from
Georgia Southern University
Base URL
digitalcommons.georgiasouthern.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Morrison, John L, Jr.. An Investigation of the Effects of N-Butanol on Friction and Wear Patterns When Mixed with Ultra Low Sulfur Diesel. Thesis (open access) thesis, https://digitalcommons.georgiasouthern.edu/etd/2094