Marshall University
CFD-coupled multi-objective optimization of a solid oxide electrolysis cell stack
Abstract
dc:description.abstractSolid oxide electrolysis cells (SOECs) can convert steam into hydrogen with lower electrical demand than lower-temperature electrolysis technologies. Their performance depends on coupled fluid flow, heat transfer, species transport, and electrochemical behavior, which makes optimization difficult because improving one response can negatively affect another. Detailed computational fluid dynamics (CFD) can capture these interactions, but the computational cost makes trial-and-error design impractical. This thesis develops a three-dimensional model of a two-cell planar SOEC stack in ANSYS Fluent and couples it directly to a customized NSGA-II in MATLAB. Each candidate design is evaluated using the CFD model rather than a surrogate. Eight variables were varied simultaneously: inlet velocity, pressure differential, inlet steam mass fraction, inlet temperature, anode reference current density, cathode reference current density, projected electrolyte area, and open circuit voltage. The two objectives were to maximize outlet hydrogen mass fraction and minimize electrical power. A population of 200 candidates over 100 generations produced nine representative non-dominated solutions. Outlet hydrogen mass fraction ranged from 0.02346 to 0.24847, while electrical power ranged from 0.93880 to 1.15877 W. The resulting Pareto front showed a nonlinear tradeoff between the two objectives. Hydrogen mass fraction increased from 0.02346 to 0.13824 while electrical power increased from 0.93880 to 0.95959 W, representing an approximately 489.3% increase in hydrogen response for about a 2.2% increase in power. At the high-hydrogen end of the front, additional increases in hydrogen mass fraction required proportionally larger increases in electrical demand, indicating diminishing returns. Across the non-dominated set, projected electrolyte area remained near the lower end of the optimization range, while anode reference current density increased from approximately 7.10×103 to 8.73×103 A/m2. Inlet temperature, velocity, pressure differential, steam fraction, cathode reference current density, and the open circuit voltage parameter varied more broadly across the Pareto set, showing that the optimizer used combinations of thermal, transport, compositional, geometric, and electrochemical effects to improve hydrogen response. Comparison with published SOEC studies showed that the predicted outlet hydrogen mass fractions were consistent with previously reported numerical behavior. The results demonstrate the feasibility of the modeled SOEC as a hydrogen production pathway and establish a CFD-coupled optimization framework that can be extended to larger stacks, additional objectives, and future hydrogen systems.
Degree
thesis:*- Name thesis:degree_name
- Mechanical Engineering
- Level thesis:degree_level
- Thesis
- Discipline thesis:degree_discipline
- College of Engineering and Computer Sciences
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Webb, Erin
- Contributors dc:contributor
-
- Dr. Asad Salem
- Dr. Yousef Sardahi
- Dr. Iyad Hijazi
Subjects
dc:subject × 9Identifiers
dc:identifier.*- Repository record dc:identifier
- https://mds.marshall.edu/etd/2162