McMaster University
Influence of Testing Configuration and Microstructure on the Deformation Behaviour of Advanced High Strength Steels in Bending
Abstract
dc:description.abstractThe development of Advanced High Strength Steels (AHSS) has been essential in achieving lighter and safer vehicles. Their multiphase microstructures, while providing a superior combination of strength and ductility, also introduce challenges during forming. Bending is a widely used forming operation in automotive manufacturing, yet the influence of microstructure and testing configuration on bending performance is not fully understood. This Ph.D. thesis advances the understanding of how these factors influence the deformation and failure behaviour of AHSS during bending. An experimental strategy was developed to investigate the macro- and microscale deformation behaviour of three AHSS grades with similar nominal strength: dual phase (DP), complex phase (CP), and quench and partition (QP) steels. At the macroscale, it was shown that the wider bending span in V-die tests led to slower strain evolution during air bending. The die contact during the drawing stage caused a rapid increase in strain and load and affected the fracture mode. A high strain hardening rate of the material promoted more uniform strain distribution at the bending spine, resulting in a slower strain evolution. At the microscale, in-situ SEM bend tests, were performed using a custom bending device and applying a simple and effective micro-DIC speckle pattern. It was shown that the high phase strength contrast in DP and QP steels caused severe microstrain partitioning. DP steel, which exhibited sharp deformation bands at the ferrite-martensite interfaces, showed increased susceptibility to interface decohesion. In contrast, damage nucleation was suppressed in CP steel due to its narrower nanohardness distribution. Synchrotron X-ray diffraction was used to characterize the strain-induced martensitic transformation kinetics in QP steel under different stress states The experimental data were incorporated into a model to predict the through-thickness evolution of retained austenite during three-point bending, yielding good agreement with experiments. The findings of this Ph.D. thesis provide a comprehensive understanding of how testing configuration and microstructure influence the bendability of AHSS, offering insights to optimize formability, improve springback prediction accuracy, and support broader industrial implementation.
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Mendes Fonseca, Nizia
Rights
- Language dc:language.iso
- en
Identifiers
dc:identifier.*- Identifier URI
- https://doi.org/10.71548/23305