McMaster University
Design, Optimization, and Control of a Hybrid-Fed Isolated Three-Port Bidirectional DC–DC Converter With PCB-Integrated Magnetics for Electric Vehicle On-Board Charging
Abstract
dc:description.abstractVehicle electrification motivates integrating the isolated dc–dc stages of the on-board charger (OBC) and auxiliary power module (APM). Interfacing an 800-V traction system with a multi-kilowatt 48-V bus creates stringent voltage-ratio, current-stress, magnetic, and packaging constraints. This thesis develops a reconfigurable hybrid-fed isolated three-port bidirectional dc–dc converter through electrical, magnetic, thermal, and mechanical co-design. Voltage-fed bridges interface the charging dc link and traction battery; an interleaved current-fed bridge interfaces the 42–56-V auxiliary bus. The converter operates as a triple-active bridge (TAB) during charging and a dual-active bridge (DAB) during vehicle operation. It is designed for 9.6 kW total charging, including a 3.6 kW auxiliary port, at 100 kHz. A generalized harmonic analysis (GHA) framework calculates port powers, transformer and semiconductor currents, losses, and switching-event conditions without enumerating switching sequences. It supports selection of the transformer leakage network and current-fed filter inductors. Against a like-for-like voltage-fed design, the current-fed interface increases the effective auxiliary-winding voltage and improves copper utilization; at full-power points, calculated loss decreases by 28.6% in DAB operation and 42.8% in TAB operation for a 3.2% increase in estimated cost. Closed-form, lookup-table-free modulation laws are derived for both modes. By separating voltage-profile mismatch from phase-shift-dependent power transfer, the methods generate pulse-width commands algebraically while retaining phase shifts for power regulation. Across both envelopes, they reproduce the RMS-current and efficiency trends of three- and five-variable particle-swarm-optimization benchmarks. A PCB-integrated planar three-winding transformer incorporates the required power-transfer leakage inductances, eliminating separate series inductors. Its eight-layer winding construction supports automated PCB fabrication and low-profile integration with the main power PCB. Measured leakage inductances agree with three-dimensional finite-element predictions within 9.4%. A liquid-cooled prototype measuring 428×285×65 mm3 and weighing 8.07 kg integrates the power stages, magnetics, control, protection, and packaging. Open-loop experiments demonstrate bidirectional DAB and TAB operation and validate the switching relationships and current trajectories. Measured RMS currents and converter efficiencies support the effectiveness of the closed-form modulation methods and the feasibility of the integrated platform.
Degree
thesis:*- Department dc:contributor.department
- Electrical and Computer Engineering
- Year dc:date.issued
- 2026
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Chakkalakkal, Sreejith
- Advisor dc:contributor.advisor
-
- Emadi, Ali
Subjects
dc:subject × 10- Electric Vehicle On-Board Charging
- Multiport Bidirectional DC–DC Converters
- Triple-Active-Bridge (TAB) Converters
- Dual-Active-Bridge (DAB) Converters
- Hybrid-Fed Converter Architecture
- PCB-Integrated Planar Magnetics
- Integrated Three-Winding Transformers
- Closed-Form Modulation and Control
- Loss Modeling and Optimization
- Power Electronics Packaging and Thermal Management
Rights
- Language dc:language.iso
- en
Identifiers
dc:identifier.*- Identifier URI
- https://doi.org/10.71548/25682