Back to search

Michigan State University

Effects of design parameters on a single-lap, bolted joint; using internal and surface strain measurement techniques

Abstract

dc:description

Composite materials have emerged as a method of engineering high strength structures to specific tasks at a low weight cost. The strength to weight ratio makes composite materials ideal for replacing metal components in vehicles, but the plates have to be thick enough to withstand impacts during service use. Often, the weakest point of any composite panel is the point at which it is fastened to the vehicle frame. A bolting method is identified as the fastening mechanism of choice and is applied to a single-lap joint geometry for this study. Fastening parameters included bolt-to-hole clearance, and the use of insertsA combination of measurements taken using embedded fiber optic strain gages, digital image correlation, and stiffness data was used to determine the optimum design characteristics. It was seen that clearance had a negative effect on the stiffness of the joint, increased clearance from the zero percent clearance had an immediate effect on decreasing the stiffness of the joint. Also, the fiber optic strain gages found that there was a significant strain concentration just inside the interface between the overlap of the bolted composite to aluminum plates. Initial increase in clearance was seen to increase this concentration. Also, in studying the use of inserts it was found that an aluminum insert at the largest diameter tested of 0.75" outer diameter was the best performing geometry. Overall, the design recommendations were that there should be minimal to no clearance, with an aluminum insert with an outer diameter of 0.75".

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Woodruff, John
Contributors dc:contributor
  • Restivo, Gaetano
  • Somerton, Craig
  • Liu, Dahsin

Subjects

dc:subject × 3

Rights

dc:rights
Statement dc:rights
  • In Copyright
Language dc:language
English

Identifiers

dc:identifier.*
Identifier
etd:1633
isbn:9781124852881
isbn:1124852883
oclc:931849382
umi:1498343
local:Woodruff_grad.msu_0128N_10547

Chain of custody

source
Harvested from
Michigan State University
Base URL
d.lib.msu.edu/oai
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Woodruff, John. Effects of design parameters on a single-lap, bolted joint; using internal and surface strain measurement techniques. 2011. https://doi.org/doi:10.25335/nvsa-y759