Back to search

Michigan Technological University

ASSESSMENT AND IMPROVEMENT OF COMPUTATIONAL FLUID DYNAMICS METHODS FOR SEPARATED TURBULENT FLOWS AT LOW REYNOLDS NUMBERS

Abstract

dc:description.abstract

This study investigates the accuracy of Computational Fluid Dynamics (CFD) models to predict heat transfer in turbulent separated flows at low Reynolds numbers. A novel improvement of a Scale Adaptive technique is also presented. A spectrum of turbulence models is used to simulate flow and heat transfer of two geometries; fully developed flow through a staggered tube bank and a square prism in cross flow. Experimental data for both local heat transfer and velocity data are available in the literature for these cases and have been used extensively evaluate various CFD methods. Six unsteady models were used and the results show that the unsteady Shear Stress Transport (SST) model provided good overall accuracy relative to the mean Nusselt number for both cases. However, the SST model failed to accurately predict local variations. The Partially Averaged Navier-Stokes variant of the SST model showed a marked improvement for both cases. The Dynamic Smagorinsky Large Eddy Simulation (LES) showed a much-improved fidelity to the local Nusselt but under predicted the actual values. The computational cost for the LES model was significant. In general, it was found that the computationally expensive models with higher degrees of resolved turbulence did not necessarily return more accurate results. A Scale Adaptive Simulation (SAS) modification of the SST model (SAS-SST) is also used in this study. The SAS approach for the SST model adjusts the production term of the specific dissipation transport equation based on the second velocity derivative. This modification is intended to improve the SST model where local flow accelerations/ xx decelerations are detected, as occurs in separated flows. However, the local Nusselt number for the two cases considered were found to be generally less accurate than the baseline SST model. In this study a novel modification to this model was made to reduce the SAS contribution near stagnation points in the simulation. This was done through the Kato-Launder and production limiter modification in the SAS production term. The results showed only a slight improvement of the accuracy of the Nusselt number predictions. It is possible that further adjustments to the SAS terms and constants can be made to properly support and complement the stagnation point modification in this study and yield an overall better turbulence model.

Degree

thesis:*
Name thesis:degree_name
Doctor of Philosophy in Mechanical Engineering-Engineering Mechanics (PhD)
Level thesis:degree_level
Open Access Dissertation
Discipline thesis:degree_discipline
Department of Mechanical Engineering-Engineering Mechanics

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Mancuso, Tom
Committee members dc:contributor.committeemember
  • Fernando Ponta
  • Seong-Young Lee
  • Gustavo Ledezma
Contributors dc:contributor
  • Abhijit Mukherjee
  • Craig Friedrich

Subjects

dc:subject × 5

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
Michigan Technological University
Base URL
digitalcommons.mtu.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Mancuso, Tom. ASSESSMENT AND IMPROVEMENT OF COMPUTATIONAL FLUID DYNAMICS METHODS FOR SEPARATED TURBULENT FLOWS AT LOW REYNOLDS NUMBERS. Open Access Dissertation thesis, https://doi.org/10.37099/mtu.dc.etdr/1072