Back to search

Michigan Technological University

Wave Energy Converter Wave Force Prediction Using a Neural Network

Abstract

dc:description.abstract

Due to the unpredictable nature of large bodies of water, wave energy can be a difficult renewable resource to rely on. One way to make Wave Energy Converters (WECs) more efficient is to apply a control strategy. In many control solutions, it is assumed that the wave excitation force is known into the future. In many instances, especially with complex waveforms, this is simply not the case. Simulation studies have shown the promise of wave force prediction using neural networks. This study demonstrates this experimentally and aims to characterize the important factors when designing such a network. Several wave elevation measurement factors are considered, including: quantity, their location relative to the buoy, and their configuration. The relationship between forecast horizon and the number of measurement backvalues is also evaluated along with both the wave form complexity and the performance impact of including instantaneous buoy acceleration. A 14.2 cm buoy, constrained to vertical motion, was subjected to 30, 60 second tests using regular and irregular waves in a wave tank. For each test its vertical motion was recorded along with an array of twelve upstream and downstream wave elevation measurements. Neural networks were trained using subsets of the data to examine the effect of the factors mentioned above on prediction performance. The results showed that upstream measurements were the most important, where the distance between the measurement and the buoy is critical. A diamond-shaped configuration of elevation measurements performed nearly the same as using all twelve measurements illustrating the importance measurement topology. It was also found that the number of past measurements used had a significant impact on performance. Specifically, performance was best when the ratio of the prediction horizon time to the number of backvalues was one. 1 gauge far upstream, 2 gauges immediately upstream, and 1 gauge to the rear performed just as well as a full set of 12 gauges. Including acceleration as an input appeared to lower the error of most of these cases as well. It was discovered that a ratio of the forecast horizon to the number of backvalues allows the network to perform its best as this ratio is near or less than 1. Further testing is required to obtain a more complete view of the impact of waveform complexity on the results of the network.

Degree

thesis:*
Name thesis:degree_name
Master of Science in Mechanical Engineering (MS)
Level thesis:degree_level
Open Access Master's Thesis
Discipline thesis:degree_discipline
Department of Mechanical Engineering-Engineering Mechanics

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Kline, Morgan
Committee members dc:contributor.committeemember
  • Jungyun Bae
  • William Endres
Contributors dc:contributor
  • Gordon Parker

Subjects

dc:subject × 9

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
Michigan Technological University
Base URL
digitalcommons.mtu.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Kline, Morgan. Wave Energy Converter Wave Force Prediction Using a Neural Network. Open Access Master's Thesis thesis, https://doi.org/10.37099/mtu.dc.etdr/1768