Back to search

NJIT

Design, simulation, fabrication and testing of microprobes for a new MEMS wafer probe card

Abstract

dc:description.abstract

A new type of MEMS cantilever wafer probe card consists of an array of microcantilevers individually actuated by bimorph heating to make contact with the test chip was designed and fabricated. This probe card is called the CHIPP (Conformable, High-Pin count, Programmable ) card and can be designed to contact up to 800 I/O pads along the perimeter of a 1 cm^2 chip with a microprobe repeat distance of ~50 um. Each microcantilever had an internal heater and a separate electrode carrying the signal under test and contained four separate layers plus a fifth material for the contact tip region. Different versions of micro-actuators have been designed and made in this Ph.D. research. Ohmic contacts were made with the lowest contact resistance of 250 m[Omega]. The deflection efficiency varied from 5.23 to 9.6 um/mW for cantilever length from 300-500 um. The maximum reversible deflection was in the range of 270 um. Video recordings made inside the SEM clearly show that ohmic contact was made to a stationery tungsten electrode. A full dynamic deflection (180 um) for a 50 x 500 um cantilever occurred in response to input frequency up to nearly 50 Hz. The motion was damped at higher frequencies, with a strong resonance (for a 50 x 500 um device) at 8160 Hz. Heat loss for devices operating in air was found to be substantially higher than for vacuum operation with a heat loss ratio of about 2/1 for a heater inside the structure; and 4.25/1 for a structure with the heater as an outer layer of the cantilever.

Degree

thesis:*
Name thesis:degree_name
Doctor of Philosophy in Electrical Engineering - (Ph.D.)
Discipline thesis:degree_discipline
Electrical and Computer Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Zhang, Yanwei
Contributors dc:contributor
  • Robert Boris Marcus
  • William N. Carr
  • Ken K. Chin

Subjects

dc:subject × 3

Identifiers

dc:identifier.*
Repository record dc:identifier
https://digitalcommons.njit.edu/dissertations/1035

Chain of custody

source
Harvested from
NJIT
Base URL
digitalcommons.njit.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Zhang, Yanwei. Design, simulation, fabrication and testing of microprobes for a new MEMS wafer probe card. https://digitalcommons.njit.edu/dissertations/1035