Back to search

NJIT

Machining of silicon wafers with an abrasive water jet cutter

Abstract

dc:description.abstract

This thesis consists of a study of the effects of abrasive water jet cutting on brittle silicon substrates. In total, 26 different cuts were made in a single crystal silicon substrate with an abrasive water jet cutter under different conditions of water flow, water pressure, and abrasive flow rate. These cuts were analyzed for surface roughness, and microstructure. The roughness measurements were compared in order to determine the best possible cutting conditions. The cut with the best roughness of 0.000170 inches was obtained under cutting conditions of 30 KSI water pressure, 1 inch/minute cutting speed, and an abrasive flow rate of 56 grams/minute. Other trends in the data show the optimum cutting speed to be between 1 and 2 inches/ minute. The water pressure of 30 KSI achieved better results than the 50 KSI presures under similar cutting conditions . At both 50KSI and 30 KSI, low abrasive flow rates result in better roughness values.

Degree

thesis:*
Name thesis:degree_name
Master of Science in Manufacturing Systems Engineering - (M.S.)
Discipline thesis:degree_discipline
Manufacturing Engineering Division

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Marciniak, Frank J.
Contributors dc:contributor
  • E. S. Geskin
  • N. M. Ravindra
  • R. S. Sodhi

Subjects

dc:subject × 6

Identifiers

dc:identifier.*
Repository record dc:identifier
https://digitalcommons.njit.edu/theses/1647

Chain of custody

source
Harvested from
NJIT
Base URL
digitalcommons.njit.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Marciniak, Frank J.. Machining of silicon wafers with an abrasive water jet cutter. https://digitalcommons.njit.edu/theses/1647