Back to search

University of North Dakota

Synthesis And Characterization Of Max Ceramics (MAXCERs)

Abstract

dc:description.abstract

This research has focused on the design and development of novel multifunctional MAX reinforced ceramics (MAXCERs). These MAXCERs were manufactured with 1-50 vol% ratios of ceramics to MAX phases. Chapter II reports on the synthesis and tribological behavior of Ti3SiC2 matrix composites by incorporating (1 and 6 vol%) Al2O3, (1 and 5 vol%) BN, and (1 and 5 vol%) B4C ceramic particulate additives in the matrix. All the composites were fabricated by pressureless sintering by using ~1 wt% Ni as a sintering agent at 1550 oC for 2 hours. SEM and XRD studies showed that Al2O3 is relatively inert in the Ti3SiC2 matrix whereas BN and B4C reacted significantly with the Ti3SiC2 matrix to form TiB2. Detailed tribological studies showed that Ti3SiC2-1wt%Ni (baseline) samples showed dual type tribological behavior where the friction coefficient (Õ© was low (~0.2) during stage 1, thereafter Õ increased sharply and transitioned into stage 2 (~0.8). The addition of Al2O3 as an additive had little effect on the tribological behavior, but the addition of B4C and BN was able to enhance the tribological behavior by increasing the transition distance (TD). Chapter III reports on the synthesis and tribological behavior of TiB2 matrix composites by incorporating (10, 30, and 50 vol%) Ti3SiC2 ceramic particulate additives in the matrix. The fabrication parameters were similar to the Ti3SiC2 samples from Chapter II. There was minimal reaction between the TiB2 and the Ti3SiC2. Detailed tribological studies showed that TiB2 (baseline) and TiB2-10%Ti3SiC2 samples showed an average Õ of ~0.29 and ~0.28, respectively. TiB2-30%Ti3SiC2 and TiB2-50%Ti3SiC2 showed dual-type tribological behavior where Õ was low (~0.25) during stage 1, thereafter Õ increased gradually and transitioned into stage 2 (~0.6). Low wear rates were seen for all samples.

Degree

thesis:*
Name thesis:degree_name
Master of Engineering (MEngr)
Level thesis:degree_level
Thesis
Discipline thesis:degree_discipline
Mechanical Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Nelson, Johnny Carl
Contributors dc:contributor
  • Surojit Gupta

Subjects

dc:subject × 1

Identifiers

dc:identifier.*
Repository record dc:identifier
https://commons.und.edu/theses/2298

Chain of custody

source
Harvested from
University of North Dakota
Base URL
commons.und.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Nelson, Johnny Carl. Synthesis And Characterization Of Max Ceramics (MAXCERs). Thesis thesis, https://commons.und.edu/theses/2298