Back to search

University of North Dakota

The Controlled Oxidation of Lignite in a Fixed Bed

Abstract

dc:description.abstract

The use of cooling coils or pipes to control the reaction zone temperatures when oxidizing lignite in a fixed bed was studied. The experimental procedures involved passing heated air through a bed of lignite to initiate spontaneous heating and then removing the heat generated using a water cooled coil. Variables investigated included the lignite moisture content, prior oxidation history, and lignite source.Spontaneous heating was initiated in lignite from three different mines, and at initial moisture contents from bed moisture down to 10 percent by heating the lignite to 250-260 °F while passing air slowly through the bed. At moisture contents below 10 percent or after severe oxidation the temperature necessary to initiate spontaneous heating rose to over 300 °F.The low thermal conductivity of the lignite bed was found to prevent adequate heat removal from the bed to permit satisfactory control of the oxidation of lignite. An equation describing the temperature distribution in the lignite between cooling pipes embedded in the oxidizing lignite was developed.

Degree

thesis:*
Name thesis:degree_name
Master of Science (MS)
Level thesis:degree_level
Thesis
Discipline thesis:degree_discipline
Chemical Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Dockter, Leroy

Identifiers

dc:identifier.*
Repository record dc:identifier
https://commons.und.edu/theses/3689

Chain of custody

source
Harvested from
University of North Dakota
Base URL
commons.und.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Dockter, Leroy. The Controlled Oxidation of Lignite in a Fixed Bed. Thesis thesis, https://commons.und.edu/theses/3689