Back to search

Rochester Institute of Technology

Native and Radiation-Induced Defects in III-V Solar Cells and Photodiodes

Abstract

dc:description.abstract

Photodiodes made of III-V materials are ubiquitous with applications for telecommunications, photonics, consumer electronics, and spectroscopy. The III-V solar cell, specifically, is a large-area photodiode that is used by the satellite industry for power conversion due to its unrivaled efficiency and wide range of available materials. As a device driven by its minority carrier diffusion length (MCDL), the performance of a photodiode is sensitive to crystallographic defects that create states in the forbidden energy gap. Defects commonly arise during growth of the crystal and during device fabrication, and they accumulate slowly over time when deployed into the damaging environment of space. Defect-assisted carrier recombination leads to lower MCDL, higher dark current, reduced sensitivity and signal-to-noise ratio, and, in the case of solar cells, reduced power conversion efficiency. Consequently, the development of photodiode technology requires techniques for detection, characterization, and mitigation of defects and the inter-bandgap states they create. In this work, III-V material defects are addressed across a variety of materials and devices. The first half of the work makes use of deep-level transient spectroscopy (DLTS) to deduce the energy level, cross-section, and density of traps the InAlAs, InAlAsSb, and InGaAs lattice-matched to InP. An in situ DLTS system that can monitor defects immediately after irradiation was developed and applied to InGaAs photodiodes irradiated by protons. Evidence of trap annealing was found to occur as low as 150 K. The second half begins with development of GaSb solar cells grown by molecular beam epitaxy on GaAs substrate intended for use in lower-cost monolithic multi-junction cells. Defect analysis by microscopy, dark lock-in thermography, and dark current measurement, among others, was performed. The best GaSb-on-GaAs cell achieved state-of-the-art 4.5% efficiency under concentrated solar spectrum. Finally, light management in III-V photodiodes was explored as a possible route for defect mitigation. Textures, diffraction gratings, metallic mirrors, and Bragg reflectors were simulated by finite difference time domain for single- and multi-junction GaAs-based cells with the aim of reducing the amount of absorber material required and to simultaneously reduce MCDL requirements by generating carriers closer to the junction. The results were inputted into a device simulator to predict efficiency. A backside reflective pyramidal-textured grating was simulated to allow a GaAs cell to be thinned by a factor of >30 compared to a conventional cell.

Degree

thesis:*
Name thesis:degree_name
Microsystems Engineering (Ph.D.)
Level thesis:degree_level
Dissertation
Discipline thesis:degree_discipline
Microsystems Engineering (KGCOE)

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Nelson, George Thomas, IV
Contributors dc:contributor
  • Seth M. Hubbard

Subjects

dc:subject × 5

Identifiers

dc:identifier.*
Repository record dc:identifier
https://repository.rit.edu/theses/10100

Chain of custody

source
Harvested from
Rochester Institute of Technology
Base URL
repository.rit.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Nelson, George Thomas, IV. Native and Radiation-Induced Defects in III-V Solar Cells and Photodiodes. Dissertation thesis, https://repository.rit.edu/theses/10100