Back to search

Rochester Institute of Technology

Experimental Simulation of Nucleating Bubble Behavior in a Microgap with Air Injected Bubbles

Abstract

dc:description.abstract

The following study investigates the behavior of bubbles created by air injection under a tapered microgap. It is a continuation of previous work from the Thermal Analysis and Microfluidics Lab at RIT which showed that placing a tapered gap manifold over a heated surface in a pool boiling setup could direct the flow of vapor created by two-phase heat transfer and create a pumping effect to increase its heat transfer performance. This study isolates this phenomenon and examines exactly how bubble motion affects liquid throughput. The results of this study provide insight into the specific parameters which induce this effect such as taper angle, flow rate of air, and manifold gap height. An experimental setup has been fabricated which mimics the flow of vapor created by pool boiling on a heated surface. It consists of a volume of water, an orifice through which air is supplied, a polysulfone taper, a peristaltic pump, and a high speed camera to record motion. Videos are saved and analyzed in a tracking software to provide position, velocity, and acceleration data. This data is used to compare taper configurations and evaluate performance. Four different flow patterns were observed during the passage of air through the microgap: “bubble squeezing”, ”bubble sticking”, ”no squeezing”, and “bubble slingshot. The installation of side curtains on the taper restricted flow to the inlet and outlet and prevented fluid from escaping from the sides. Taper angle and inlet area were seen to be the most influential parameters in the flow pattern outcome for the bubble. The most desirable flow patterns are “bubble squeezing” and “bubble slingshot” as they provide higher interface velocities indicative of increased liquid throughput. This is expected to improve the heat transfer during boiling in this geometry.

Degree

thesis:*
Name thesis:degree_name
Mechanical Engineering (MS)
Level thesis:degree_level
Thesis
Discipline thesis:degree_discipline
Mechanical Engineering (KGCOE)

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Green, Jack
Contributors dc:contributor
  • Satish G. Kandlikar

Subjects

dc:subject × 3

Identifiers

dc:identifier.*
Repository record dc:identifier
https://repository.rit.edu/theses/11354

Chain of custody

source
Harvested from
Rochester Institute of Technology
Base URL
repository.rit.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Green, Jack. Experimental Simulation of Nucleating Bubble Behavior in a Microgap with Air Injected Bubbles. Thesis thesis, https://repository.rit.edu/theses/11354