Back to search

South Dakota State University

Electrophoretic Deposition of Si and TiO2 Nanoparticle-based Films for Solar Cell Applications

Abstract

dc:description.abstract

Thin film Si solar cells are expected to meet the future demand of hundreds of gigawatts due to the vast abundance of Si feedstock, non-toxicity, less susceptibility to moisture, fewer encapsulation challenges, and mature processing methods. High efficiency thin film Si solar cells can be obtained using microcrystalline Si thin films and highly reflective and light scattering back reflectors. However there is a need for methods that can rapidly and uniformly produce large-area Si nanoparticle-based films that can be re-crystallized into microcrystalline Si, and rapidly produce large-area TiO2 nanoparticlebased (pigment) back reflectors compatible with roll-to-roll processing, high density plasmas, and high vacuum environments. Si nanoparticle suspension stability was improved from a few minutes to a few days with the addition of alcohol. An alcohol reverse micelle stability mechanism was proposed. Dense Si nanoparticle-based films were produced without agglomerations at lower electrophoretic deposition voltages. Compared to as-deposited Si nanoparticle films, the photonic cured films were comprised of mostly larger globules with up to micron sized diameters, suggesting that Si nanoparticles were melted into liquid form and re-solidified when cooled into larger globules. Raman spectra indicated that the Si globules were comprised of low-defect, high-crystallinity Si.A pigment suspension comprised of a spin-on-glass solution and 410 nm TiO2 pigments (DuPont) remained milky white for multiple days with minimal sedimentation indicating high stability. The reflection spectrum of TiO2 pigment-based back reflector was higher or comparable to Ag/ZnO. The spectra of the pigment-based back reflector was diffuse. In comparison, the diffuse reflection of the Ag/ZnO and Al/ZnO back reflectors was significantly lower than their total reflection and about a third less than the TiO2 pigment-based back reflector. The highest solar cell photocurrent and efficiency was achieved with the TiO2 pigment-based back reflector followed by Ag/ZnO and Al/ZnO. The resistivity of the pigment-based back reflector/hole/ITO nanoparticle films was on the order of 102 to 104 Ω·cm. A 4 inch wide by 6 feet TiO2 pigment-based back reflector was produced by continuous deposition roll-to-roll and did not show cracking or peel off damage while being flexed or rewound on the take up roller.

Degree

thesis:*
Name thesis:degree_name
Doctor of Philosophy (PhD)
Level thesis:degree_level
Dissertation - University Access Only
Discipline thesis:degree_discipline
Electrical Engineering and Computer Science

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Bills, Braden
Contributors dc:contributor
  • Qi Hua Fan

Rights

dc:rights
Statement dc:rights
  • <p>In Copyright - Non-Commercial Use Permitted<br /><a href="http://rightsstatements.org/vocab/InC-NC/1.0/">http://rightsstatements.org/vocab/InC-NC/1.0/</a></p>
Language dc:language
en

Identifiers

dc:identifier.*
Repository record dc:identifier
https://openprairie.sdstate.edu/etd/2047

Chain of custody

source
Harvested from
South Dakota State University
Base URL
openprairie.sdstate.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Bills, Braden. Electrophoretic Deposition of Si and TiO2 Nanoparticle-based Films for Solar Cell Applications. Dissertation - University Access Only thesis, https://openprairie.sdstate.edu/etd/2047