Back to search

South Dakota State University

Simulations of Impinging Jet with a Range of Configuration

Abstract

dc:description.abstract

Impinging jet technique is widely increasing across the globe due to its ability to produce high heat and mass transfer as compared to other traditional methods. Three cases of impinging jets related to cooling technologies for a gas turbine were investigated. The first case involves a single jet impinging on a flat plate. The second case has an array of jets impinging on a curved surface. The third case deals with simulating impinging jet in crossflow. The first case was used for validation and shows the effect of mesh and inlet boundary conditions. After careful observation, it was seen that at least 15 or more prism layers should be used for these types of simulation. Also, SST turbulence model gives the best output for all the cases discussed below. For the fenot [11] case, jet-to-jet spacing (P/d) of 4 was observed to give best heat transfer. Turbulence modeling and jet versus crossflow ratio was compared, and passive scalar mixing was performed and was observed that as the crossflow increases, the heat transfer gets worse.

Degree

thesis:*
Name thesis:degree_name
Master of Science (MS)
Level thesis:degree_level
Thesis - Open Access
Discipline thesis:degree_discipline
Mechanical Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Singh, Devansh
Contributors dc:contributor
  • Jeffrey Doom

Subjects

dc:subject × 2

Rights

dc:rights
Language dc:language
en

Identifiers

dc:identifier.*
Repository record dc:identifier
https://openprairie.sdstate.edu/etd/2151

Chain of custody

source
Harvested from
South Dakota State University
Base URL
openprairie.sdstate.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Singh, Devansh. Simulations of Impinging Jet with a Range of Configuration. Thesis - Open Access thesis, https://openprairie.sdstate.edu/etd/2151