South Dakota State University
Evaluation of the Mechanical Properties of 3D Printed Carbon Fiber Composites
Abstract
dc:description.abstractStudies have been done involving the use of carbon fiber as a reinforcement for three dimensional (3D) printed parts. The Markforged Mark Two is a commercial grade 3D printer capable of printing parts reinforced with continuous fibers such as carbon fiber, Kevlar, and fiberglass. Short Carbon Fiber Composite tensile specimen were printed on both a Markforged Mark Two and Flashforge Creator Pro using Markforged Onyx filament. The results of these parts were compared for their tensile properties, dimensional accuracy, and mass estimates. The Creator Pro was capable of producing stronger parts on average, while the Mark Two produced more dimensionally accurate parts. Parts printed with the Creator Pro achieved higher Ultimate Tensile Strengths and Elastic Moduli than their respective Mark Two counterparts on average. Various analytical models were employed to estimate the Elastic Modulus of these parts printed at 100% infill. The Modified Rule of Mixtures Model was found to be the most accurate estimate of these short fiber composites. Continuous Carbon Fiber Composite tensile specimen were printed with a Markforged Mark Two. Various Carbon Fiber orientations and layer proximities were tested and their effects on Tensile Strength and Modulus of Elasticity were examined. A Volume Average Stiffness (VAS) model was also used to predict the elastic properties of these 3d-printed specimen. Tensile Testing of the 3d-printed specimen showed that material properties were directly related to the number of carbon fiber strands loaded in tension within the part, and that the increase in these material properties was linear. Impact specimen were printed with a Markforged Mark Two. Both short/discontinuous and long continuous carbon fiber specimen were printed. For the Continuous fiber specimen, effects of part orientation, number of carbon fiber layers, and carbon fiber layer proximity were studied. For short fiber specimen, layer height and material infill raster angles were studied.
Degree
thesis:*- Name thesis:degree_name
- Master of Science (MS)
- Level thesis:degree_level
- Thesis - Open Access
- Discipline thesis:degree_discipline
- Mechanical Engineering
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Sauer, Max James
- Contributors dc:contributor
-
- Todd Letcher
Subjects
dc:subject × 1Rights
dc:rights- Language dc:language
- en
Identifiers
dc:identifier.*- Repository record dc:identifier
- https://openprairie.sdstate.edu/etd/2436