Back to search

South Dakota State University

Evaluation of a Machine Vision System for 3-D Location of Harvestable Mushrooms

Abstract

dc:description.abstract

A machine vision system was developed and tested to locate and describe geometric characteristics of harvestable size mushrooms in a growing environment. An imaging system was built to scan half of a commercial mushroom tray. A camera perpendicular to the tray surface collected images, which were used to calculate diameter and estimate X and Y axes coordinates for each mushroom. A camera placed at an angle of approximately 45 degrees to the tray surface collected images of structured laser light on each mushroom. The actual 3-D coordinates of the mushroom center were calculated along with orientation in X and Y direction with this information. A second measurement system, referred to as the electromechanical measurement system, was developed as a standard to asses [sic] the capability of the machine vision system. The electromechanical measurement system was designed to measure 3-0 coordinates, diameter and tilt of mushrooms in a growing tray. This system was made up of two linear transducers, an ultrasonic sensor, inclinometer and digital caliper. These components were interfaced with an IBM compatible PC through RS-232 serial ports, a mouse communication port and a Keithley DAS 800 data acquisition board. A program developed using Microsoft C++ and assembly programming languages performed the data collection and manipulation. The 3-D center coordinates, diameter and tilt of mushrooms located correctly by both measurement systems were compared. Confidence intervals were calculated for all the parameters measured. The following conclusions were drawn for the machine vision system. The X coordinate measured by the machine vision system was determined to a region of ± 1.3 cm about the value measured by the electromechanical system at a 95% confidence level. The Y coordinate, at a 95% confidence level, was determined to a region of ± 1.5 cm. Errors in height measured on side two were more variable than side one of the tray because of compost height variation. A 95% confidence interval was used to determine mushroom heights to within ± 1.2 cm of the height measured by the electromechanical system on side one. The diameter estimates showed more variability on side two of the tray. Mushroom diameters measured from side one of the tray [sic] were estimated by the machine vision system within ± 8.85 mm about the diameter measured by the electromechanical measurement system at a 95% confidence level. Angle estimations were better in the X direction than in the Y direction, but both were poor. The machine vision system had more problems identifying severely tilted mushrooms.

Degree

thesis:*
Name thesis:degree_name
Master of Science (MS)
Level thesis:degree_level
Thesis - University Access Only
Discipline thesis:degree_discipline
Agricultural Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Murray, Timothy A.
Contributors dc:contributor
  • Daniel S. Humburg

Subjects

dc:subject × 2

Rights

Language dc:language
English

Identifiers

dc:identifier.*
Repository record dc:identifier
https://openprairie.sdstate.edu/etd/5897

Chain of custody

source
Harvested from
South Dakota State University
Base URL
openprairie.sdstate.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Murray, Timothy A.. Evaluation of a Machine Vision System for 3-D Location of Harvestable Mushrooms. Thesis - University Access Only thesis, https://openprairie.sdstate.edu/etd/5897