University of Southampton
The influence of suction changes on the stiffness of railway formation
Abstract
dc:description.abstractDespite compacted soils being unsaturated, geotechnical design is predominantly based on saturated soils,<br/>despite it being known that differences exist between the behaviour of saturated and unsaturated soils.<br/>Suction in soils has been shown to increase its strength and stiffness with the increase dependent on the<br/>degree of suction, soil type and particle arrangement. Future climate change predictions suggest an<br/>increase in average global temperatures leading to longer drier summers and wetter winters resulting in<br/>seasonal fluctuations in suction, such that unsaturated soil behaviour will become more important.<br/><br/>Transport infrastructure such as railway tracks, founded at shallow depths, are likely to be unsaturated<br/>and influenced by variations in suction. A key parameter in assessing the performance of soils is stiffness;<br/>in particular shear modulus, however, although suction affects shear modulus, limited research has been<br/>conducted into its influence. This research, therefore, considers how variations in suction influence the<br/>small strain shear modulus of railway formation material.<br/><br/>Soil water characteristic curves were determined, using the pressure plate apparatus and filter paper<br/>technique, for four materials covering the spectrum of railway formation materials encountered on the<br/>COALlink line in South Africa. Shear modulus measurements of specimens prepared from two of these<br/>materials were determined using a Stokoe resonant column apparatus. Suction was controlled by<br/>preparing specimens at different water contents, with the suction independently measured using the filter<br/>paper technique.<br/><br/>Results showed that shear modulus was significantly influenced by suction and exhibited a complex<br/>behaviour. For specimens tested at their preparation water content shear modulus increased with<br/>increasing suction up to an optimum value, and then reduced as suctions exceeded this optimum value<br/>forming a bell-shaped curve. The influence of suction was seen to be greater at lower net normal stresses.<br/>Although this behavioural pattern was similar for both materials tested in the resonant column apparatus,<br/>the peak value of shear modulus increased with clay content. Importantly, the marked changes in shear<br/>modulus due to suction coincided with the suction range predicted in-situ.<br/><br/>Tests were also conducted on specimens prepared at different water contents but the same density, airdried<br/>to very low water contents. The shear moduli of these air dried specimens were markedly higher<br/>than those of the dry and unsaturated specimens tested at their preparation water contents. Variation in<br/>measured shear modulus between specimens led to the conclusion that different particle arrangements<br/>between the specimens may have also contributed to the changes in shear modulus and were dependent<br/>on the preparation water content. At high water contents the clay particles became evenly distributed<br/>around the sand particles when the specimen was prepared, whilst, at low water contents the clay formed<br/>lumps during preparation of the material mix and became embedded with the sand particles during<br/>formation. CT scanning undertaken to look at the particle arrangement highlighted regions throughout the<br/>specimen where sand particles were embedded in lumps of clay and silt particles.<br/><br/>These results are the first to demonstrate the importance of suction and its variation on the small strain<br/>shear modulus behaviour of railway formation material.
Degree
thesis:*- Name dc:type.qualificationname
- Ph.D.
- Level dc:type.qualificationlevel
- doctoral
- Grantor dc:publisher.institution
- University of Southampton
- Year dc:date.issued
- 2011
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Otter, Louise
- Advisors dc:contributor.advisor
-
- Priest, J.A.
- Clayton, C.R.I.
- ORCID person:identifier.orcid
Rights
- Language dc:language.dcterms_iso639_2
- eng