Back to search

University of Southampton

Investigation of tip-driven thruster and waterjet propulsion systems

Abstract

dc:description.abstract

<p>Experimental and computational techniques have been used to study the performance of a tip-driven propeller (TDP) and a waterjet intake duct for the purpose of assessing the practical implications of using a tip-driven impeller in a waterjet propulsion system. A prototype electromagnetic tip-driven propeller has been successfully designed and built for the specific purpose of experimental analysis. This unit has been tested in towing tanks for a range of propeller speeds, advance speeds and duct shapes. In conjunction with the towing tank tests a potential-flow panel model (with viscous coupled duct) has been developed in order to predict the likely performance of the prototype thruster. The model has been validated against both the towing tank results, and against published data for standard ducted propeller units.</p><p>A representative waterjet intake duct has been tested using an open-circuit wind tunnel. Velocity proffles and surface pressure distributions have been obtained for three different flow regimes. In addition, a CFD model of the same inlet duct geometry has been developed using a fully viscous, commercial RANS flow solver. This model is validated against the wind tunnel test data and has been further developed to study the influence of trim and drift on the flow through the duct. In addition, a brief study on duct-hull interaction is presented.</p><p>Results from the experimental and computational tests on both the tip-driven propeller and waterjet intake duct are presented. The two validated CFD models are subsequently coupled together to investigate the performance implications of using a tip-driven, rather than shaft-driven, axial-flow waterjet impeller. It is shown that the use of a tip-driven impeller in a waterjet propulsion system has the potential to increase hydrodynamic performance. Removing the drive shaft from the system resulted in an increase in predicted impeller thrust of approximately <i>KT=0.1. </i>Finally, the practical implications of such a drive mechanism are discussed. It is seen that the use of an electromagnetic tip-drive is limited by the physical size of the motor.</p><p></p>

Degree

thesis:*
Name dc:type.qualificationname
Ph.D.
Level dc:type.qualificationlevel
doctoral
Grantor dc:publisher.institution
University of Southampton
Year dc:date.issued
2000

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Hughes, Adam William

Rights

Language dc:language
English, eng

Chain of custody

source
Harvested from
University of Southampton
Base URL
eprints.soton.ac.uk/cgi/oai2
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Hughes, Adam William. Investigation of tip-driven thruster and waterjet propulsion systems. doctoral thesis, University of Southampton, 2000.