Back to search

University of Strathclyde

Assessment of membrane distillation modules for seawater desalination and oilfield-produced water treatment applications

Abstract

dc:description.abstract

Membrane distillation (MD) is a technology that is emerging as a viablealternative to traditional desalination techniques such as Reverse Osmosis, Multistage flash distillation, Multiple-effect distillation, Vapour-compression evaporation,etc. The advantages of MD over conventional desalination technologies includehigher ionic rejection capacity, greater feasibility for high saline brine treatments,ability to operate using low-grade heat energy, a single-stage process and remoteoperation using renewable energy, among others.In this dissertation, a parametric study was performed using experiments toassess the feasibility of using direct contact membrane distillation (DCMD)technology to desalinate saline water of different concentrations. The results showedthat the permeate flux increased to 37.1 L/m².h from 11.6 L/m².h when thetemperature was raised from 45 °C to 75 °C. Additionally, the permeate fluxdecreased to 13.6 L/m2.h from 27.3 L/m2.h, and the reduction in flux was around50% when the concentration of sodium chloride in the feed solution was increasedfrom 0% to 26%.The experimental results obtained using oilfield-produced water were highlyencouraging. The permeate flux was 11.5 L/m².h and 12.5 L/m².h at 80 °C and 85°C, respectively. The results indicate the enormous potential of DCMD to treathypersaline oilfield-produced water, with an overall rejection of salts above 99%. Thebase-line technology is the DCMD technology.This study also evaluated the viability of air-gap membrane distillation(AGMD) and vacuum membrane distillation (VMD) for treating different types ofsaline water (3.5%, 7%, 15% and 26% NaCl solutions), including Arabian GulfSeawater (AGS) and oilfield-produced water. AGMD experiments at different feedtemperatures found that increasing the test temperature from 70 °C to 85 °Cincreased the permeate flux by 56.64%. In contrast, the VMD experiments showedthat increasing the feed temperature from 65 °C to 85 °C resulted in a 26.87%increase in permeate flux. The results obtained from the experiments showed thatVMD performed better at higher feed concentrations, while AGMD was superior atlower feed concentrations. The flow-rate experimental results showed that increasingthe flow rate from 1.3 to 2.0 litres per minute resulted in a 1.2-fold increase inpermeate flux for both configurations, with salt rejection close to 99.9% and unaffected by the feed flow rate. AGMD outperformed VMD at all flow rates, and theincrease in permeate flux with flow rate was similar for both configurations.This study found lower gaps, i.e. air gap and vacuum space, were preferred inAGMD and VMD configurations, respectively, as they showed good flux, potentiallydue to the reduced effects of heat and mass-transfer mechanisms at smaller gaps.The experimental results showed that AGMD and VMD processes were highlyefficient in treating oilfield-produced water and AGS, achieving high salt rejections ashigh as 99.97%. The results showed that the tested membranes achieved saltrejections as high as 99.97%, and the order of fluxes observed in the VMDconfiguration was Polyvinylidene fluoride (PVDF) > Polypropylene (PP) >Polytetrafluoroethylene (PTFE). In the AGMD configuration, the order of fluxesobserved was Polypropylene (PP) > Polyvinylidene fluoride (PVDF) >Polytetrafluoroethylene (PTFE).This study’s results will provide valuable insights into the potential applicationsof AGMD and VMD processes in desalination, especially in regions where freshwaterresources are scarce or contaminated. The information gained from this study canbe used to optimise the performance of these processes, improve their costeffectiveness and energy efficiency, and enhance their viability as potential solutionsfor addressing water scarcity and pollution issues. The study discussed in thisdissertation is the first to present laboratory-scale results of using AGMD and VMDtechnologies to treat AGS and oilfield-produced water in Kuwait while consideringprevailing conditions. The findings of this study lay the groundwork for conductingpilot-scale studies on Arabian Gulf Seawater and oilfield-produced water utilisingDCMD, AGMD and VMD technologies, not only in the Middle East region butglobally.

Degree

thesis:*
Name dc:type.qualificationname
phd
Level dc:type.qualificationlevel
doctoral-pg
Grantor dc:publisher.institution
University of Strathclyde
Year dc:date.issued
2025

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Alsairfi, Hussain
Advisors dc:contributor.advisor
  • Minisci, Edmondo
  • Koshuriyan, Zamir
Author Identifier dc:creator.authoridentifier
  • 202087858

Rights

Identifiers

dc:identifier.*
Identifier
T17223

Chain of custody

source
Harvested from
University of Strathclyde
Base URL
stax.strath.ac.uk/catalog/oai
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Alsairfi, Hussain. Assessment of membrane distillation modules for seawater desalination and oilfield-produced water treatment applications. doctoral-pg thesis, University of Strathclyde, 2025. https://stax.strath.ac.uk/concern/theses/6d56zx233