Back to search

University of British Columbia

High Density supersolidus liquid phase sintering of steel powders

Abstract

dc:description

In this study, supersolidus liquid phase sintering (SLPS) of an industrially relevant Fe-C-Mo alloy powder was investigated with particular attention to the evolution of density and porosity. The material was produced by mixing graphite with a prealloyed Fe-Mo alloy. Differential Scanning Calorimetry (DSC) was employed to determine the solidus and liquidus temperatures of the alloy, and a high temperature experimental furnace was used to provide information on density evolution as a function of time and temperature. Specimens were sintered both in the solid state and in the presence of a supersolidus liquid phase, over a range of temperatures between 1000 and 1300°C, providing both densification data and metallographic specimens. Diffusion calculations and thermodynamic calculations using Thermocalc™ software were performed to complement the experimental data. On heating, several processes occur in the material prior to liquid formation, including delubrication of the material, phase transformation, carbon diffusion, and solid state sintering. It was determined that the carbon diffusion is rapid and the bulk concentration is homogeneous at temperatures well below those of first liquid formation. Following homogenization, some solid state sintering takes place, and while minimal densification occurs, the number of pores decreases markedly from the green state. At temperatures above the solidus where a liquid phase is present, it was found that densification occurs in two regimes. The first regime involves a fast rate of densification due to the capillary forces of the liquid, followed by a second, slower regime of densification that is governed by pore removal processes. The maximum amount of densification possible is determined by the fraction of liquid present, as defined by the sintering temperature. If the temperature is low, insufficient liquid is present and densification is extremely slow. If the temperature is too high, the liquid promotes distortion of the semi-solid sample; in addition, pores subject to sufficient internal gas pressure are capable of expansion in the weakened structure, actually increasing the volume of porosity. Samples were, however, successfully sintered to densities approaching theoretical in a narrow temperature window intermediate between these extremes. Recommendations for the development of robust sintering practices are offered.

Degree

thesis:*
Name thesis:degree_name
Master of Applied Science - MASc
Level thesis:degree_level
master's
Discipline thesis:degree_discipline
Materials Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
2002

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Young, Erin

Rights

dc:rights
Statement dc:rights
  • For non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/12290

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Young, Erin. High Density supersolidus liquid phase sintering of steel powders. master's thesis, University of British Columbia, 2002. http://hdl.handle.net/2429/12290