Back to search

University of British Columbia

Inkjet printing of transducers

Abstract

dc:description

In the past few years, inkjet printing has been emerging as a cost effective, environment friendly, net-shape microfabrication technique. This non-contact deposition technique facilitated the deposition of metallic and polymeric inks, biological proteins, and cells. The present work investigates the inkjet printing of microtransducers, with a focus on stress-sensing and movable microstructures. Piezoresistive and interdigitated capacitor based strain gauges were printed and tested. The inexpensive conductive polymer, poly(3,4-ethylenedioxythiophene) oxidized with poly(styrenesulfonate) (PEDOT:PSS), was used as base material. We have performed measurements on several test structures to show that PEDOT:PSS does preserve its piezoresistive properties after printing. As we were relying further on PEDOT:PSS as a base material for printed transducers, the mechanical and electrical properties of this commercially available ink were comprehensively investigated. A dedicated experimental setup, which was used for the mechanical and electrical characterization of test structures, and micro-topography measurements were combined in order to extract the parameters of the PEDOT:PSS thin film: a zero-stress electrical conductivity of G=201 S/cm and gauge factor of 3.63. The longitudinal and transversal piezoresistive coefficients were estimated to be, [formula omitted] and [formula omitted] respectively, which denote a piezoresistive material in a similar range of piezoresistivity as n-doped silicon and conventionally fabricated PEDOT:PSS. A second explored direction was using inkjet microprinting technology for the fabrication of movable microstructures. An inkjet-printed CMUT (capacitive micromachined ultrasound transducer) was the target device, using ZnO as sacrificial layer and PEDOT:PSS as structural layer. The printed ZnO sacrificial layer was too rough, non-uniform and with a high porosity, so that printing a conductive membrane on top of it was unsuccessful. An alternative solution approach used kapton tape, a polyimide, as movable membrane; experimental characterization has shown that the structure is not properly clamped along its rim, yielding a vibraion at a frequency of 1.1 KHz, when actuated, compared to a resonant frequency of 9.3 KHz achieved by finite element analysis of the CMUT structure. The approach shows enough promise for further investigations, along directions suggested at the end of the thesis.

Degree

thesis:*
Name thesis:degree_name
Master of Applied Science - MASc
Level thesis:degree_level
master's
Discipline thesis:degree_discipline
Electrical and Computer Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
2010

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Al-Chami, Hussein

Rights

dc:rights
Statement dc:rights
  • Attribution-NonCommercial-NoDerivatives 4.0 International
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/28260

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Al-Chami, Hussein. Inkjet printing of transducers. master's thesis, University of British Columbia, 2010. http://hdl.handle.net/2429/28260