Back to search

University of British Columbia

Friction sawing of wood

Abstract

dc:description

The friction sawing of wood by a high speed rotating disk has been studied. The present experiments were carried out by sawing two commonly used timbers; namely, Douglas fir and Western red cedar of different moisture Contents. A 14 inch diameter, 14 gauge steel disk with a smooth edge, driven at a rotating speed of 4,620 rpm was used for the research. A theoretical analysis of heat transmission characteristics and temperature distribution in the sawing disk is presented. Experimental results showed that the frictional forces, power consumed and cutting temperatures increased as feed speeds increased. The results also showed that the moisture content of the wood had no noticeable influence on the sawing action. A narrow kerf, straight, smooth and polished cut surfaces are some of the advantageous features of the process. At low feed speeds the calculated cutting edge temperatures were well below the ignition temperature of the wood specimen. However at high feed speeds the experimental horse power values increased and high calculated cutting edge temperatures consequently obtained. Excessive power consumption and high cutting edge temperatures were believed to be related to the difficulty of disposition of cut material with a smooth edge disk. Reasonably high feed speeds were evident in cutting plywood and veneer. For these materials clean, smooth and polished cut surfaces were evident. The method may be advantageous in the cutting of plastic sheets. When cutting thicker lumber with this method the feed speed was confined to an impractical low level and power consumed was far higher than that required for ordinary sawing. Thus, whether this method of sawing can be put into practical use or not is determined by the possibility of having an effective means to dispose of cut material. In this connection several methods of modifying the disk for more efficient cutting and waste disposal are presented.

Degree

thesis:*
Name thesis:degree_name
Master of Applied Science - MASc
Level thesis:degree_level
master's
Discipline thesis:degree_discipline
Mechanical Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
1966

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Yu, Kwei Cho

Rights

dc:rights
Statement dc:rights
  • For non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/36477

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Yu, Kwei Cho. Friction sawing of wood. master's thesis, University of British Columbia, 1966. http://hdl.handle.net/2429/36477