Back to search

University of British Columbia

Evaporated silicon thin-film transistors

Abstract

dc:description

The method of fabrication, the theory and the properties of evaporated silicon thin-film transistors are discussed. The device consists of a p-type silicon film (0.5 to 2µ thick) on a sapphire substrate, with aluminum source-drain electrodes evaporated onto the silicon and followed by a silicon oxide, SiOx , insulating layer and an aluminum gate. The device operates by field-effect conductivity modulation of an n-type inversion layer at the surface of the p-type film. The silicon films were evaporated by electron beam heating in a typical vacuum of 7 x 10⁻⁷ mm Hg at a rate of 200-600 Å/min. The films exhibited single crystal diffraction patterns when deposited at a substrate temperature in the range 1050°C to 1100°C. They were found to be high resistivity ( > 400 Ω -cm) p-type and the hole mobility was of the order of 20-30 cm² /volt-sec. The minority carrier lifetime, was 1-2 µsec and the optical absorption edge of the films was found to be broader than the absorption edge of single crystal silicon at all substrate temperatures. The low carrier mobility and minority carrier lifetime as well as the broadening of the optical absorption edge are attributed to the presence of a large number of crystallographic defects in the films. The effective surface state density at the Si/ evaporated SiOx interface was estimated by the MOS technique and was found to be of the same order of magnitude (3 - 4 x 10¹¹ cm⁻² ) as that at the Si/thermally grown SiO₂ interface. The silicon surface potential in the MOS structure was found to be particularly susceptible to water vapour and contamination by sodium. The silicon thin-film transistors fabricated have typical effective mobilities of 5-10 cm² /volt-sec with transconductances as high as 100 µmho and gain-bandwidth products up to 1 MHz. Surface trapping was found to affect the behavior of the devices at low gate voltages. The characterization of the traps by a method which involves measurements of the source-drain conductance, its temperature dependence and its transient response is discussed. The effect of surface scattering on the mobility at high gate voltages is also considered. The device characteristics were stable in vacuum but drifted when exposed to the atmosphere.

Degree

thesis:*
Name thesis:degree_name
Doctor of Philosophy - PhD
Level thesis:degree_level
doctoral
Discipline thesis:degree_discipline
Electrical and Computer Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
1966

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Salama, Clement Andre Tewfik

Rights

dc:rights
Statement dc:rights
  • For non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/37213

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Salama, Clement Andre Tewfik. Evaporated silicon thin-film transistors. doctoral thesis, University of British Columbia, 1966. http://hdl.handle.net/2429/37213