Back to search

University of British Columbia

Disintegration of sludge using ozone-hydrodynamic cavitation

Abstract

dc:description

In our study we applied hydrodynamic cavitation and ozonation both separately and combined, to determine the synergistic effect of these two technologies for sludge disintegration. A 2 mm orifice was used as a cavitation device. Ozone was injected after cavitation at a concentration of 35 mg/L at a flow of 3 Lpm. The sludge was subjected to treatment for 90 minutes in all three cases. In a final step, combined ozone and cavitation was applied to disintegrate the sludge for 10 hours. It was found that the combination of ozonation and cavitation exhibited higher sludge disintegration capacity than the individual technologies applied alone. About 31% of VSS was reduced by the combined system, whereas 19% was reduced by ozone and only 4% was reduced by cavitation alone after 90 minutes of treatment. Soluble chemical oxygen demand (SCOD) was increased by approximately 1600 mg/L in the combined system, which was much higher than the individual effect observed with either ozone or cavitation alone. About 75% of this SCOD was found to be biodegradable. In the combined system, soluble TOC increased by approximately 1.5 times the amount released by ozone alone, indicating higher release of organic matter from biomass. Only cavitation did not show any significant release of soluble total organic carbon (TOC) compared to the other treatments. In combined application, soluble biochemical oxygen demand (BOD) increased to 420 mg/L, which was significantly higher than the increase of BOD due to the application of ozone alone which was 260 mg/L. Based on the SCOD, it was found that a maximum of 50% of the sludge could be solubilised in 10 hours of combined treatment. It was also found that with ozone-cavitation, approximately 26% of the total sludge phosphorus was released to the solution after 10 hours, although most of the release occured within the first 2 hours. Within the operating conditions applied, cavitation itself was not sufficient for the disintegration of sludge, although better disintegration was found in combined application at higher inlet pressure. In the case of ozonation alone, higher disintegration was obtained at longer ozonation time.

Degree

thesis:*
Name thesis:degree_name
Master of Applied Science - MASc
Level thesis:degree_level
master's
Discipline thesis:degree_discipline
Civil Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
2012

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Chanda, Suranjit Kumar

Rights

dc:rights
Statement dc:rights
  • Attribution-NonCommercial-NoDerivatives 4.0 International
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/43105

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Chanda, Suranjit Kumar. Disintegration of sludge using ozone-hydrodynamic cavitation. master's thesis, University of British Columbia, 2012. http://hdl.handle.net/2429/43105