Back to search

University of British Columbia

The effect of edge knots on the strength of Western SPF MSR lumber

Abstract

dc:description

Mill visits were conducted to evaluate the effect of Visual Quality Level (VQL) restrictions of edge knots on the yields of Machine Stress Rated (MSR) lumber. This initial study indicated that edge knots contribute significantly to the amount of MSR lumber that is being downgraded because of visual override requirements, representing in excess of $15,000 per month in lost revenue to MSR producers. Therefore, an experimental study was initiated to study the effect of large VQL (edge knots) on the strength properties of Spruce-Pine-Fir (SPF) MSR lumber. Two groups of material were studied that had been graded by a Continuous Lumber Tester (CLT) to receive a 1650E-1.5Fb MSR grade designation. One group called on-grade complied with the visual override requirements and the other group, VQL, should contained at least one edge knot with a VQL greater than 25 % of the cross sectional area. All specimens were nominal 38 mm x 89 mm SPF lumber collected from the same MSR production run. Manual measurements of the VQLs was conducted on all 750 specimens and they were then tested nondestructively to determine flat-wise and edge-wise modulus of elasticity. All the specimens were randomly divided into either tension or third point bending testing since these are the most commonly used destructive tests. There were weak relationships noted between the measured VQL size and destructive strength values. Strength results were as expected in that tension strength proved to be more important and restrictive. Even when some boundaries were placed on the VQL size the tension specimens failed to meet the grade requirements while the bending specimens exceeded the requirements in all cases. This results from the fact that MSR production of SPF lumber is governed by the MOE value determined by the CLT. It is not controlled by the bending strength as is the case for Douglas-fir; whose strength values were used in the VQL size determination. Two procedures, simulation and proportionality, were used to determine the amount of large VQL material that can be included with the current on-grade production and meet grade requirements. These procedures were conducted with the various VQL groups for both destructive tests and confirmed that tension strength is the governing factor. The results highlight the importance of the amount of VQL material to include in a grade; therefore, proper and thorough testing by organizations is required for large VQL inclusion.

Degree

thesis:*
Name thesis:degree_name
Master of Science - MSc
Level thesis:degree_level
master's
Discipline thesis:degree_discipline
Forestry
Grantor dc:publisher
University of British Columbia
Year dc:date
1996

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Courchene, Terry

Rights

dc:rights
Statement dc:rights
  • For non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/4724

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Courchene, Terry. The effect of edge knots on the strength of Western SPF MSR lumber. master's thesis, University of British Columbia, 1996. http://hdl.handle.net/2429/4724