Back to search

University of British Columbia

The leaching and passivation of chalcopyrite in acid sulfate media

Abstract

dc:description

Sulfate-based leaching processes for chalcopyrite (CuFeSa) are attractive because of their inherent simplicity. Unfortunately, high copper extractions are not attainable in a reasonable residence time unless the leaching temperature exceeds 200°C (oxygen pressure leaching) or chalcopyrite is "activated" by a pretreatment method prior to leaching. In the present work, the oxygen pressure leaching behaviour of chalcopyrite in the temperature range 110-220°C was studied to shed new light on the reasons for the slow leaching. At temperatures where molten elemental sulfur is stable (120-180°C), the reaction was found to be prematurely stifled by liquid sulfur formed during leaching. The liquid sulfur wetted and agglomerated the unreacted mineral particles, effectively stopping the leach at 40-70% copper extraction. The feasibility of using surfactants to disperse the sulfur and enhance the copper extraction in the temperature range 125-155°C was investigated. Most of the surfactants tested decomposed too rapidly to be of benefit. The best results were obtained with orthophenylenediamine (OPD) when it was added continuously at a low temperature (125°C) and a high dosage (50 kg/t). Under these conditions the surfactant was successful in dispersing liquid sulfur and it effected a modest increase in copper extraction over that obtained at 110°C, but only after prolonged retention times (6 hours). It was found that chalcopyrite leached slowly even if molten sulfur was prevented from wetting the mineral surfaces. This led to the conclusion that the reaction rate is ultimately controlled by a passivating mechanism unrelated to elemental sulfur formation. Oxidized chalcopyrite mineral surfaces were examined by Auger electron spectroscopy and X-ray photoelectron spectroscopy to identify the presence of any passivating layers that may form during leaching. The results indicated that an iron-deficient, copper-rich sulfide layer forms on the surface of chalcopyrite as a result of solid state changes that occur in the mineral during leaching. This layer is thought to be a copper polysulfide, CuS[sub]n, where n > 2. The layer is quite thin (-10-100 nm) and hence is not detectable by conventional electron microscopy. The copper polysulfide is believed to passivate the chalcopyrite. The addition of silver ions at a temperature below the sulfur melting point (110°C) was found to catalyze the leach, resulting in the copper extraction increasing from 53% to 96% after 3 hours leaching. Silver alone was ineffective at 125°C and 155°C because the leach was stifled by liquid sulfur. However, when silver was used in conjunction with OPD at 125°C the copper extraction was again enhanced significantly, to 91%. The OPD prevented the sulfur from wetting the mineral surfaces, allowing the catalytic effect of the silver ions to be maintained. A simple mathematical model was formulated to explain the leaching and passivation of chalcopyrite at low temperature (110°C). The reaction kinetics can be explained in terms of a mixed diffusion/chemical reaction model where the reaction rate is initially dependent on the rate at which copper and iron diffuse through the thickening passive layer. The passive layer also leaches, but at a slower rate than the chalcopyrite. Eventually, the passive layer reaches a steady state thickness and the kinetics are then controlled by the rate at which the passivating layer decomposes. The linear rate constant k\ for the decomposition of the passive layer was calculated to be 5.0x10⁻³ um/min. The low value of k\ explains why inordinately long residence times are required to obtain a high copper extraction from chalcopyrite at 110°C.

Degree

thesis:*
Name thesis:degree_name
Doctor of Philosophy - PhD
Level thesis:degree_level
doctoral
Discipline thesis:degree_discipline
Materials Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
1995

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Hackl, Ralph Peter

Rights

dc:rights
Statement dc:rights
  • For non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/4834

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Hackl, Ralph Peter. The leaching and passivation of chalcopyrite in acid sulfate media. doctoral thesis, University of British Columbia, 1995. http://hdl.handle.net/2429/4834