Back to search

University of British Columbia

Discrete element modeling of direct simple shear response of granular soils and model validation using laboratory tests

Abstract

dc:description

The direct simple shear (DSS) device is one of the most commonly used laboratory testing tools to characterize the shear behavior of soils. In the Norwegian Geotechnical Institute (NGI) version of the DSS test, where a cylindrical soil specimen is confined by a wire-reinforced membrane, only normal and shear stresses on the horizontal planes are measured. The knowledge of these stresses alone does not provide adequate information to calculate friction angles for use in geotechnical design. Further, the absence of complementary shear stresses at the soil-membrane interface causes stress non-uniformities within DSS specimens, which makes the task of interpreting DSS testing results even more difficult. With the recent advances in computers, it is now possible to model soil in a realistic manner as a collection of particles using the discrete element method (DEM). With this background, a DEM model of a cylindrical DSS specimen was developed to provide insight on the state of stress and strain in DSS specimens. A laboratory DSS testing program was undertaken on glass beads as part of this study. The results of the glass beads tests were used for comparison with the DEM model results. Further, free-form sensors (paper-thin flexible pressure sensors mounted on the reinforced part of the DSS membrane) were used to measure lateral stresses acting on reconstituted Fraser River silt specimens. It was shown that: i) the adopted DEM modeling approach is effective in capturing the salient characteristics of the DSS behavior of the tested glass beads; ii) during the shearing phase, the distribution of shear strains across the specimen is more uniform at lower shear strain levels; iii) significant stress non-uniformities during shearing are limited to a narrow zone of about two particles diameter near the lateral boundaries, while stresses at central specimen locations are relatively more uniform (i.e. most representative of “ideal” simple shear conditions); and iv) at large shear strains, the horizontal plane becomes the plane of maximum obliquity, and the friction angle calculated using the stress state on the horizontal plane is a good approximation to the mobilized friction angle at such strain levels.

Degree

thesis:*
Name thesis:degree_name
Doctor of Philosophy - PhD
Level thesis:degree_level
doctoral
Discipline thesis:degree_discipline
Civil Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
2014

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Dabeet, Antone

Rights

dc:rights
Statement dc:rights
  • Attribution-NonCommercial-NoDerivs 2.5 Canada
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/48510

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Dabeet, Antone. Discrete element modeling of direct simple shear response of granular soils and model validation using laboratory tests. doctoral thesis, University of British Columbia, 2014. http://hdl.handle.net/2429/48510