Back to search

University of British Columbia

The use of mixing-sensitive chemical reactions for the study of pulp fibre suspension mixing

Abstract

dc:description

The competitive, consecutive azo coupling between 1-naphthol and diazotized sulphanilic acid was used to investigate the mixing of a pulp fibre suspension in a stirred tank reactor operated in a semi-batch mode. The distribution between the mono and bis substituted product dyes depended upon the turbulent intensity in the reaction zone and was used to indicate the degree of mixing in the vessel. Coupling reactions were carried out under conditions where macromixing did not influence the product distribution and were used to indicate the turbulent dissipation and microscale mixing in the reaction zone. When fibres were present in the reactor some of the product dyes were adsorbed onto the fibres. Adsorption rate was not proportional to the equilibrium concentration of the dyes and it was necessary to correct the measured product distribution to account for the differential adsorption rates. Once this correction had been made the product distribution correctly indicated the degree of mixing. As the dyes were found to have different affinities for different pulps, separate correlations would have to be developed for each pulp tested. All results reported here were obtained with a commercially produced fully bleached kraft pulp. Tests were conducted in the stirred vessel using aqueous media and at fibre suspension concentrations up to 2.5% by mass. Test results in aqueous media compared favourably with past work and a predictive model developed by Baldyga and Bourne. In the presence of fibres a reduction in turbulent energy dissipation was detected under most operating conditions when compared with the aqueous tests. When the suspension mass concentration was increased to the point where the vessel contents ceased to be in complete motion the product distribution began to increase due to macroscale mixing effects. The technique could not be applied successfully to a high-shear mixer due to the high energy dissipation rates and dye adsorption, both of which reduced the product distribution below the analytical detection limit. While other mixing sensitive chemical reactions are available to permit mixing determination at these high dissipation rates, the extension of the reaction system to more than 3 adsorbable components would make the measurements difficult to conduct and interpret.

Degree

thesis:*
Name thesis:degree_name
Master of Applied Science - MASc
Level thesis:degree_level
master's
Discipline thesis:degree_discipline
Chemical and Biological Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
1992

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Thangavel, V. K.

Rights

dc:rights
Statement dc:rights
  • For non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/5445

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Thangavel, V. K.. The use of mixing-sensitive chemical reactions for the study of pulp fibre suspension mixing. master's thesis, University of British Columbia, 1992. http://hdl.handle.net/2429/5445