University of British Columbia
Stability and electrochemical regeneration of activated carbon electrodes for capacitive deionization
Abstract
dc:descriptionThe stability and electrochemical regeneration of activated carbon electrodes used for Capacitive Deionization have been investigated. To assess the electrode state, electrochemical properties such as capacitance and potential at the point of zero charge (EPZC) were monitored and complemented by elemental composition, wettability and bulk porosity analysis. Long-term cycling was performed with electrolytes containing dissolved organic matter (DOM) and iron (II) under anaerobic and aerobic conditions. It was found that DOM, at concentrations of up to 40 mg L-¹, had a marginal impact on capacitance loss and relocation of the EPZC. On the other hand, the scaling nature of iron was apparent from early cycling stages, in waters containing as little as 0.2 mg Fe²⁺ L-¹. In all cases performed, elemental composition analysis demonstrated that incorporation of oxygen to the surface occurred predominantly during the first 15 to 20 cycles. Specifically, the oxygen content increased by a factor of four. Over this time frame, the contact angle decreased from approx. 130˚ to 34˚, on average; which indicated an increase in electrode wettability. In addition, cycling experiments with simple electrolytes revealed improved electrode stability as cycling time increased and as pH decreased. Degradation tests conducted using a two-electrode cell demonstrated the effect of reaction coupling between the processes of carbon corrosion and oxygen reduction. As a result, electrode decay occurred at an accelerated rate. Electrochemical regeneration was proven successful at recovering the electrode capacitance but not at regressing the EPZC. Their corresponding response surfaces were mapped through a 32-factorial design of experiments and revealed a significant potential dependence. Further tests revealed a point of maximum recovery near a potential of -1.68 V vs RHE and 50 s of holding time. Furthermore, the contribution of a regenerative step to the long-term electrode stability was assessed. In general, an improved retention of capacitance was observed during the first 25 cycles. However, it was noted that most of the capacitance recovered was lost in the subsequent degradation cycles. Consequently, the apparent initial improvement did not translate to an extension of the electrode lifetime, deeming this approach inadequate to mitigate the effect of carbon corrosion.
Degree
thesis:*- Name thesis:degree_name
- Doctor of Philosophy - PhD
- Level thesis:degree_level
- doctoral
- Discipline thesis:degree_discipline
- Chemical and Biological Engineering
- Grantor dc:publisher
- University of British Columbia
- Year dc:date
- 2020
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Serrano Mora, Adrian
Rights
dc:rights- Statement dc:rights
-
- Attribution-NonCommercial-NoDerivatives 4.0 International
- Language dc:language
- eng
Identifiers
dc:identifier.*- Handle dc:identifier
- http://hdl.handle.net/2429/75658