Back to search

University of British Columbia

Graphitization of lignocellulosic bio-mass via hydrothermal carbonization and spark-plasma sintering : application in lithium-ion batteries

Abstract

dc:description

Graphite is the dominant anode material used in lithium-ion batteries; however, conventional graphite production relies on mining or energy-intensive graphitization processes that exceed 2500 ºC. This dissertation investigates a sustainable alternative through the production of bio-graphite from lignocellulosic biomass using a combination of hydrothermal carbonization (HTC) and spark plasma sintering (SPS). Multiple biomass feedstocks, including arbutus bark, coffee grounds, seaweed, milfoil, and sawdust, were converted into hydrochar through HTC. The effects of feedstock type and HTC processing conditions on yield, composition, and structural development were evaluated. Increasing HTC temperature and time promoted carbon enrichment and aromatization while reducing oxygen content and solid yield. Among the feedstocks investigated, arbutus bark produced hydrochar with favourable characteristics for subsequent graphitization. The hydrochars were converted into graphitic carbon using SPS at temperatures between 1200 ºC and 1900 ºC, pressures between 5 MPa and 60 MPa, and hold times of 10 and 30 minutes. Raman spectroscopy, X-ray diffraction, elemental analysis, pycnometry, and thermogravimetric analysis demonstrated that SPS temperature was the dominant parameter controlling graphitic ordering and crystallite development. The optimized condition of 1900 ºC, 40 MPa, and 10 minutes produced the highest relative degree of graphitic ordering (among conditions investigated) while requiring substantially lower temperatures and shorter processing times than conventional graphitization methods. The optimized SPS-derived bio-graphite was evaluated as a lithium-ion battery anode material. Following particle size reduction, the material exhibited stable reversible lithium storage with discharge capacities of approximately 140-150 mAh/g and capacity retention of 84-92% after 500 cycles. Extended cycling to 1000 cycles demonstrated continued reversible lithium-storage behaviour, while rate capability testing showed measurable capacity retention at rates up to 9 C. Overall, this work demonstrated that HTC followed by SPS is a viable route for producing graphitic carbon from renewable biomass feedstocks. Although the electrochemical performance remained below that of highly optimized commercial graphite, the resulting bio-graphite exhibited promising cycling stability, extended cycle life, and reasonable rate capability while being produced using significantly reduced graphitization temperatures and processing times.

Degree

thesis:*
Name thesis:degree_name
Doctor of Philosophy - PhD
Level thesis:degree_level
doctoral
Discipline thesis:degree_discipline
Mechanical Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
2026

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Barrett, Mitchell Ross
Contributors dc:contributor
  • Bichler, Lukas

Rights

dc:rights
Statement dc:rights
  • Attribution-NonCommercial-NoDerivatives 4.0 International
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/95345

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Barrett, Mitchell Ross. Graphitization of lignocellulosic bio-mass via hydrothermal carbonization and spark-plasma sintering : application in lithium-ion batteries. doctoral thesis, University of British Columbia, 2026. http://hdl.handle.net/2429/95345