Back to search

University of British Columbia

Pilot ignited high pressure direct injection of natural gas fueling of diesel engines

Abstract

dc:description

Measurements of performance and emissions of a Diesel engine fueled with natural gas have been made with high-pressure direct-injection (HPDI). Natural gas is injected late in the compression cycle preceded by an injection of diesel pilot. Tests were performed on a DDC 1-71 Diesel engine with electronic controls. Influence of several physical parameters has been investigated in light of the results obtained by other researchers through 3-dimensional numerical simulation of the combustion process using a modified KTVA code. These were: natural gas injection pressure, absolute beginning of injection (BOI) and relative timing between injection of pilot diesel and natural gas (RBOI). It was found that, on the range of 100 to 160 bar, combustion rate and NO₂ emissions increase with gas injection pressure. Best thermal efficiency results were obtained for a gas pressure of 130 bar. With HPDI fueling of a diesel engine, injection timing delay has proven to be an effective way of reducing NO₂ emissions. By appropriately adjusting beginning of injection, NO₂ reduction of up to 60 % over the diesel baseline could be obtained, while preserving conventional diesel efficiency. Over the BOI and load range of study, a longer relative injection delay appears to give lower NO₂ emissions and improved thermal efficiency. KTVA 2 simulations indicate that the interlace angle (defined as the angle between the diesel and gas plumes as viewed in the direction of the cylinder axis), which changes during engine operation, has a significant effect on combustion rate and NO₂ emissions. Experimentally it was observed that with an equal number (6) of nozzle holes for both natural gas and diesel pilot there was instability in engine operation at low load and wide scatter in emission measurements. Guided by the simulation results it was found experimentally that data reproduciblity and engine operating stability could both be much improved by choosing a different number of jets for injection of natural gas. An arrangement of 7 natural gas and 6 diesel holes has proven to give better results of engine stability, thermal efficiency and exhaust emissions. KTVA 2 simulations indicate attachment of the gas jets to the fire deck for inclination angles less than about 20 degrees. The reduced contact area between the flame and oxygen lead to somewhat lower combustion rate and NO₂ emissions.

Degree

thesis:*
Name thesis:degree_name
Master of Applied Science - MASc
Level thesis:degree_level
master's
Discipline thesis:degree_discipline
Mechanical Engineering
Grantor dc:publisher
University of British Columbia
Year dc:date
1999

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Dumitrescu, Silviu

Rights

dc:rights
Statement dc:rights
  • For non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.
Language dc:language
eng

Identifiers

dc:identifier.*
Handle dc:identifier
http://hdl.handle.net/2429/9690

Chain of custody

source
Harvested from
University of British Columbia
Base URL
circle.library.ubc.ca/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Dumitrescu, Silviu. Pilot ignited high pressure direct injection of natural gas fueling of diesel engines. master's thesis, University of British Columbia, 1999. http://hdl.handle.net/2429/9690